spi: spi-ath79: fix initial GPIO CS line setup

commit 61d1cf163c8653934cc8cd5d0b2a562d0990c265 upstream.

The 'ath79_spi_setup_cs' function initializes the chip
select line of a given SPI device in order to make sure
that the device is inactive.

If the SPI_CS_HIGH bit is set for a given device, it
means that the CS line of that device is active HIGH
so it must be set to LOW initially. In case of GPIO
CS lines, the 'ath79_spi_setup_cs' function does the
opposite of that due to the wrong GPIO flags.

Fix the code to use the correct GPIO flags.

Reported-by: Ronald Wahl <ronald.wahl@raritan.com>
Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
Signed-off-by: Mark Brown <broonie@linaro.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/drivers/spi/spi-ath79.c b/drivers/spi/spi-ath79.c
index e504b7636058b4aa31789c26a1be8752a531456b..23f1ba6e9ccf2dc7de759784406cbb96a22789dc 100644 (file)
--- a/drivers/spi/spi-ath79.c
+++ b/drivers/spi/spi-ath79.c
@@ -132,9 +132,9 @@ static int ath79_spi_setup_cs(struct spi_device *spi)
 
                flags = GPIOF_DIR_OUT;
                if (spi->mode & SPI_CS_HIGH)
-                       flags |= GPIOF_INIT_HIGH;
-               else
                        flags |= GPIOF_INIT_LOW;
+               else
+                       flags |= GPIOF_INIT_HIGH;
 
                status = gpio_request_one(cdata->gpio, flags,
                                          dev_name(&spi->dev));