drivers/net/arm/Kconfig

   1 #
   2 # Acorn Network device configuration
   3 #  These are for Acorn's Expansion card network interfaces
   4 #
   5 config ARM_AM79C961A
   6         bool "ARM EBSA110 AM79C961A support"
   7         depends on NET_ETHERNET && ARM && ARCH_EBSA110
   8         select CRC32
   9         help
  10           If you wish to compile a kernel for the EBSA-110, then you should
  11           always answer Y to this.
  12
  13 config ARM_ETHER1
  14         tristate "Acorn Ether1 support"
  15         depends on NET_ETHERNET && ARM && ARCH_ACORN
  16         help
  17           If you have an Acorn system with one of these (AKA25) network cards,
  18           you should say Y to this option if you wish to use it with Linux.
  19
  20 config ARM_ETHER3
  21         tristate "Acorn/ANT Ether3 support"
  22         depends on NET_ETHERNET && ARM && ARCH_ACORN
  23         help
  24           If you have an Acorn system with one of these network cards, you
  25           should say Y to this option if you wish to use it with Linux.
  26
  27 config ARM_ETHERH
  28         tristate "I-cubed EtherH/ANT EtherM support"
  29         depends on NET_ETHERNET && ARM && ARCH_ACORN
  30         select CRC32
  31         help
  32           If you have an Acorn system with one of these network cards, you
  33           should say Y to this option if you wish to use it with Linux.
  34
  35 config ARM_ETHER00
  36         tristate "Altera Ether00 support"
  37         depends on NET_ETHERNET && ARM && ARCH_CAMELOT
  38         help
  39           This is the driver for Altera's ether00 ethernet mac IP core. Say
  40           Y here if you want to build support for this into the kernel. It
  41           is also available as a module (say M here) that can be inserted/
  42           removed from the kernel at the same time as the PLD is configured.
  43           If this driver is running on an epxa10 development board then it
  44           will generate a suitable hw address based on the board serial
  45           number (MTD support is required for this). Otherwise you will
  46           need to set a suitable hw address using ifconfig.