drivers: power: report battery voltage in AOSP compatible format

[GitHub/mt8127/android_kernel_alcatel_ttab.git] / Documentation / dmatest.txt

diff --git a/Documentation/dmatest.txt b/Documentation/dmatest.txt
index 279ac0a8c5b11dd12305e8ce8f0a15ce8a3aaaef..132a094c7bc3790631b664efb20b6cfb21a3d42e 100644 (file)
--- a/Documentation/dmatest.txt
+++ b/Documentation/dmatest.txt
@@ -34,7 +34,7 @@ command:
 After a while you will start to get messages about current status or error like
 in the original code.
 
-Note that running a new test will stop any in progress test.
+Note that running a new test will not stop any in progress test.
 
 The following command should return actual state of the test.
        % cat /sys/kernel/debug/dmatest/run
@@ -52,8 +52,8 @@ To wait for test done the user may perform a busy loop that checks the state.
 
 The module parameters that is supplied to the kernel command line will be used
 for the first performed test. After user gets a control, the test could be
-interrupted or re-run with same or different parameters. For the details see
-the above section "Part 2 - When dmatest is built as a module..."
+re-run with the same or different parameters. For the details see the above
+section "Part 2 - When dmatest is built as a module..."
 
 In both cases the module parameters are used as initial values for the test case.
 You always could check them at run-time by running