From f741494363c6c90e6744117d2771bbdf0fb3c455 Mon Sep 17 00:00:00 2001 From: Chen-Yu Tsai Date: Sun, 29 May 2016 15:04:42 +0800 Subject: [PATCH] mmc: fix mmc mode selection for HS-DDR and higher When IS_ERR_VALUE was removed from the mmc core code, it was replaced with a simple not-zero check. This does not work, as the value checked is the return value for mmc_select_bus_width, which returns the set bit width on success. This made eMMC modes higher than HS-DDR unusable. Fix this by checking for a positive return value instead. Fixes: 287980e49ffc ("remove lots of IS_ERR_VALUE abuses") Cc: Arnd Bergmann Signed-off-by: Chen-Yu Tsai Acked-by: Hans de Goede Reviewed-by: Krzysztof Kozlowski Acked-by: Jaehoon Chung Reviewed-by: Shawn Lin Tested-by: Marcel Ziswiler Tested-by: Bjorn Andersson Signed-off-by: Ulf Hansson --- drivers/mmc/core/mmc.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c index c984321d1881..5d438ad3ee32 100644 --- a/drivers/mmc/core/mmc.c +++ b/drivers/mmc/core/mmc.c @@ -1276,7 +1276,7 @@ static int mmc_select_hs200(struct mmc_card *card) * switch to HS200 mode if bus width is set successfully. */ err = mmc_select_bus_width(card); - if (!err) { + if (err >= 0) { val = EXT_CSD_TIMING_HS200 | card->drive_strength << EXT_CSD_DRV_STR_SHIFT; err = __mmc_switch(card, EXT_CSD_CMD_SET_NORMAL, @@ -1583,7 +1583,7 @@ static int mmc_init_card(struct mmc_host *host, u32 ocr, } else if (mmc_card_hs(card)) { /* Select the desired bus width optionally */ err = mmc_select_bus_width(card); - if (!err) { + if (err >= 0) { err = mmc_select_hs_ddr(card); if (err) goto free_card; -- 2.20.1