From ecd0cb003fda30702c6c1f007a58bef885f5cb42 Mon Sep 17 00:00:00 2001 From: "Mark A. Allyn" Date: Fri, 10 Feb 2012 13:53:08 +0000 Subject: [PATCH] staging: sep: update initialisation In particular we want to always do the reconfigure [This is picked out of the differences between the upstream driver and the staging driver. I'm resolving the differences as a series of updates -AC] Signed-off-by: Alan Cox Signed-off-by: Greg Kroah-Hartman --- drivers/staging/sep/sep_main.c | 26 +++++++++++++------------- 1 file changed, 13 insertions(+), 13 deletions(-) diff --git a/drivers/staging/sep/sep_main.c b/drivers/staging/sep/sep_main.c index 1fcabca72d40..db51895f5b16 100644 --- a/drivers/staging/sep/sep_main.c +++ b/drivers/staging/sep/sep_main.c @@ -4150,7 +4150,6 @@ static int __devinit sep_probe(struct pci_dev *pdev, dev_dbg(&sep->pdev->dev, "sep probe: PCI obtained, " "device being prepared\n"); - dev_dbg(&sep->pdev->dev, "revision is %d\n", sep->pdev->revision); /* Set up our register area */ sep->reg_physical_addr = pci_resource_start(sep->pdev, 0); @@ -4213,38 +4212,39 @@ static int __devinit sep_probe(struct pci_dev *pdev, goto end_function_deallocate_sep_shared_area; /* The new chip requires a shared area reconfigure */ - if (sep->pdev->revision != 0) { /* Only for new chip */ - error = sep_reconfig_shared_area(sep); - if (error) - goto end_function_free_irq; - } + error = sep_reconfig_shared_area(sep); + if (error) + goto end_function_free_irq; sep->in_use = 1; /* Finally magic up the device nodes */ /* Register driver with the fs */ error = sep_register_driver_with_fs(sep); - if (error) + + if (error) { + dev_err(&sep->pdev->dev, "error registering dev file\n"); goto end_function_free_irq; + } + sep->in_use = 0; /* through touching the device */ #ifdef SEP_ENABLE_RUNTIME_PM pm_runtime_put_noidle(&sep->pdev->dev); pm_runtime_allow(&sep->pdev->dev); pm_runtime_set_autosuspend_delay(&sep->pdev->dev, SUSPEND_DELAY); pm_runtime_use_autosuspend(&sep->pdev->dev); + pm_runtime_mark_last_busy(&sep->pdev->dev); sep->power_save_setup = 1; #endif - - sep->in_use = 0; - /* register kernel crypto driver */ +#if defined(CONFIG_CRYPTO) error = sep_crypto_setup(); if (error) { - dev_dbg(&sep->pdev->dev, "crypto setup fail\n"); + dev_err(&sep->pdev->dev, "crypto setup failed\n"); goto end_function_free_irq; } - +#endif goto end_function; end_function_free_irq: @@ -4292,7 +4292,7 @@ static void sep_remove(struct pci_dev *pdev) /* Free the shared area */ sep_unmap_and_free_shared_area(sep_dev); - iounmap((void __iomem *)sep_dev->reg_addr); + iounmap(sep_dev->reg_addr); #ifdef SEP_ENABLE_RUNTIME_PM if (sep->in_use) { -- 2.20.1