From da2dd6184b6178c12ca3d953356962a6ef5cfaff Mon Sep 17 00:00:00 2001 From: Benjamin Rood Date: Fri, 30 Oct 2015 10:53:24 -0400 Subject: [PATCH] pm80xx: configure PHY settings based on subsystem vendor ID Previuosly, all PMC Sierra 80xx controllers are assumed to be a motherboard controller, except if the subsystem vendor ID was equal to PCI_VENDOR_ID_ADAPTEC. The driver then attempts to load PHY settings from NVRAM. While this may be correct behavior for most controllers, it does not work with Adaptec and ATTO controllers since they do not store PHY settings in NVRAM and choose to use either custom PHY settings or chip defaults. Loading random values from NVRAM may cause the controllers to malfunction in this edge case. Signed-off-by: Benjamin Rood Reviewed-by: Jack Wang Reviewed-by: Hannes Reinecke Signed-off-by: Martin K. Petersen --- drivers/scsi/pm8001/pm8001_init.c | 26 ++++++++++++++++++++------ 1 file changed, 20 insertions(+), 6 deletions(-) diff --git a/drivers/scsi/pm8001/pm8001_init.c b/drivers/scsi/pm8001/pm8001_init.c index 5c0356fb6310..8c094fd2faa1 100644 --- a/drivers/scsi/pm8001/pm8001_init.c +++ b/drivers/scsi/pm8001/pm8001_init.c @@ -720,6 +720,23 @@ static int pm8001_get_phy_settings_info(struct pm8001_hba_info *pm8001_ha) return 0; } +/** + * pm8001_configure_phy_settings : Configures PHY settings based on vendor ID. + * @pm8001_ha : our hba. + */ +static int pm8001_configure_phy_settings(struct pm8001_hba_info *pm8001_ha) +{ + switch (pm8001_ha->pdev->subsystem_vendor) { + case PCI_VENDOR_ID_ATTO: + case PCI_VENDOR_ID_ADAPTEC2: + case 0: + return 0; + + default: + return pm8001_get_phy_settings_info(pm8001_ha); + } +} + #ifdef PM8001_USE_MSIX /** * pm8001_setup_msix - enable MSI-X interrupt @@ -902,12 +919,9 @@ static int pm8001_pci_probe(struct pci_dev *pdev, pm8001_init_sas_add(pm8001_ha); /* phy setting support for motherboard controller */ - if (pdev->subsystem_vendor != PCI_VENDOR_ID_ADAPTEC2 && - pdev->subsystem_vendor != 0) { - rc = pm8001_get_phy_settings_info(pm8001_ha); - if (rc) - goto err_out_shost; - } + if (pm8001_configure_phy_settings(pm8001_ha)) + goto err_out_shost; + pm8001_post_sas_ha_init(shost, chip); rc = sas_register_ha(SHOST_TO_SAS_HA(shost)); if (rc) -- 2.20.1