From a7c222d30f48732452ce50a00cdf4a0b92bf7957 Mon Sep 17 00:00:00 2001 From: Al Cooper Date: Tue, 3 Sep 2019 07:51:14 -0400 Subject: [PATCH] mmc: sdhci: Fix incorrect switch to HS mode [ Upstream commit c894e33ddc1910e14d6f2a2016f60ab613fd8b37 ] When switching from any MMC speed mode that requires 1.8v (HS200, HS400 and HS400ES) to High Speed (HS) mode, the system ends up configured for SDR12 with a 50MHz clock which is an illegal mode. This happens because the SDHCI_CTRL_VDD_180 bit in the SDHCI_HOST_CONTROL2 register is left set and when this bit is set, the speed mode is controlled by the SDHCI_CTRL_UHS field in the SDHCI_HOST_CONTROL2 register. The SDHCI_CTRL_UHS field will end up being set to 0 (SDR12) by sdhci_set_uhs_signaling() because there is no UHS mode being set. The fix is to change sdhci_set_uhs_signaling() to set the SDHCI_CTRL_UHS field to SDR25 (which is the same as HS) for any switch to HS mode. This was found on a new eMMC controller that does strict checking of the speed mode and the corresponding clock rate. It caused the switch to HS400 mode to fail because part of the sequence to switch to HS400 requires a switch from HS200 to HS before going to HS400. Suggested-by: Adrian Hunter Signed-off-by: Al Cooper Signed-off-by: Ulf Hansson Signed-off-by: Sasha Levin --- drivers/mmc/host/sdhci.c | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c index 9540fda7fc6b..3741d4c846e5 100644 --- a/drivers/mmc/host/sdhci.c +++ b/drivers/mmc/host/sdhci.c @@ -1635,7 +1635,9 @@ void sdhci_set_uhs_signaling(struct sdhci_host *host, unsigned timing) ctrl_2 |= SDHCI_CTRL_UHS_SDR104; else if (timing == MMC_TIMING_UHS_SDR12) ctrl_2 |= SDHCI_CTRL_UHS_SDR12; - else if (timing == MMC_TIMING_UHS_SDR25) + else if (timing == MMC_TIMING_SD_HS || + timing == MMC_TIMING_MMC_HS || + timing == MMC_TIMING_UHS_SDR25) ctrl_2 |= SDHCI_CTRL_UHS_SDR25; else if (timing == MMC_TIMING_UHS_SDR50) ctrl_2 |= SDHCI_CTRL_UHS_SDR50; -- 2.20.1