From 8a799590005180b1010912be096c1302e2bd06da Mon Sep 17 00:00:00 2001 From: Stefan Agner Date: Wed, 2 Sep 2015 18:06:35 -0700 Subject: [PATCH] mtd: nand: vf610_nfc: add device tree bindings Signed-off-by: Bill Pringlemeir Acked-by: Shawn Guo Signed-off-by: Stefan Agner [Brian: fixup #size-cells in example] Signed-off-by: Brian Norris --- .../devicetree/bindings/mtd/vf610-nfc.txt | 59 +++++++++++++++++++ 1 file changed, 59 insertions(+) create mode 100644 Documentation/devicetree/bindings/mtd/vf610-nfc.txt diff --git a/Documentation/devicetree/bindings/mtd/vf610-nfc.txt b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt new file mode 100644 index 000000000000..c96eeb65f450 --- /dev/null +++ b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt @@ -0,0 +1,59 @@ +Freescale's NAND flash controller (NFC) + +This variant of the Freescale NAND flash controller (NFC) can be found on +Vybrid (vf610), MPC5125, MCF54418 and Kinetis K70. + +Required properties: +- compatible: Should be set to "fsl,vf610-nfc". +- reg: address range of the NFC. +- interrupts: interrupt of the NFC. +- #address-cells: shall be set to 1. Encode the nand CS. +- #size-cells : shall be set to 0. +- assigned-clocks: main clock from the SoC, for Vybrid <&clks VF610_CLK_NFC>; +- assigned-clock-rates: The NAND bus timing is derived from this clock + rate and should not exceed maximum timing for any NAND memory chip + in a board stuffing. Typical NAND memory timings derived from this + clock are found in the SoC hardware reference manual. Furthermore, + there might be restrictions on maximum rates when using hardware ECC. + +- #address-cells, #size-cells : Must be present if the device has sub-nodes + representing partitions. + +Required children nodes: +Children nodes represent the available nand chips. Currently the driver can +only handle one NAND chip. + +Required properties: +- compatible: Should be set to "fsl,vf610-nfc-cs". +- nand-bus-width: see nand.txt +- nand-ecc-mode: see nand.txt + +Required properties for hardware ECC: +- nand-ecc-strength: supported strengths are 24 and 32 bit (see nand.txt) +- nand-ecc-step-size: step size equals page size, currently only 2k pages are + supported +- nand-on-flash-bbt: see nand.txt + +Example: + + nfc: nand@400e0000 { + compatible = "fsl,vf610-nfc"; + #address-cells = <1>; + #size-cells = <0>; + reg = <0x400e0000 0x4000>; + interrupts = ; + clocks = <&clks VF610_CLK_NFC>; + clock-names = "nfc"; + assigned-clocks = <&clks VF610_CLK_NFC>; + assigned-clock-rates = <33000000>; + + nand@0 { + compatible = "fsl,vf610-nfc-nandcs"; + reg = <0>; + nand-bus-width = <8>; + nand-ecc-mode = "hw"; + nand-ecc-strength = <32>; + nand-ecc-step-size = <2048>; + nand-on-flash-bbt; + }; + }; -- 2.20.1