From 703404ea441fc198d03ca3e9edbac6e09b5415f4 Mon Sep 17 00:00:00 2001 From: Jamie Lenehan Date: Tue, 19 Dec 2006 12:16:06 +0900 Subject: [PATCH] sh: allow earlyprintk baud rate to be set via command line This allows the baud rate for earlyprintk for sh4 without the standard BIOS to be set via the command line. This uses the same format as i386 and x86_64, which is: earlyprintk=serial,ttySC1,38400 The second parameter (ttySC1 above) is usually the console device name or the io address of the serial port. I allow that to be specified but ignore it in order to keep the format the same as i386/x86_64. Signed-off-by: Jamie Lenehan Signed-off-by: Paul Mundt --- arch/sh/kernel/early_printk.c | 24 ++++++++++++++++++++++-- 1 file changed, 22 insertions(+), 2 deletions(-) diff --git a/arch/sh/kernel/early_printk.c b/arch/sh/kernel/early_printk.c index 560b91cdd15c..9048c0326d87 100644 --- a/arch/sh/kernel/early_printk.c +++ b/arch/sh/kernel/early_printk.c @@ -106,12 +106,32 @@ static struct console scif_console = { }; #if defined(CONFIG_CPU_SH4) && !defined(CONFIG_SH_STANDARD_BIOS) +#define DEFAULT_BAUD 115200 /* * Simple SCIF init, primarily aimed at SH7750 and other similar SH-4 * devices that aren't using sh-ipl+g. */ -static void scif_sercon_init(int baud) +static void scif_sercon_init(char *s) { + unsigned baud = DEFAULT_BAUD; + char *e; + + if (*s == ',') + ++s; + + if (*s) { + /* ignore ioport/device name */ + s += strcspn(s, ","); + if (*s == ',') + s++; + } + + if (*s) { + baud = simple_strtoul(s, &e, 0); + if (baud == 0 || s == e) + baud = DEFAULT_BAUD; + } + ctrl_outw(0, scif_port.mapbase + 8); ctrl_outw(0, scif_port.mapbase); @@ -167,7 +187,7 @@ int __init setup_early_printk(char *buf) early_console = &scif_console; #if defined(CONFIG_CPU_SH4) && !defined(CONFIG_SH_STANDARD_BIOS) - scif_sercon_init(115200); + scif_sercon_init(buf + 6); #endif } #endif -- 2.20.1