From 4f1a0ee11d6f9c104c8e6a13dae995709a6922a8 Mon Sep 17 00:00:00 2001 From: Robert Hancock Date: Thu, 30 Jul 2009 14:11:29 -0600 Subject: [PATCH] sata_sil24: always set protocol override for non-ATAPI data commands The sil24 hardware has a built-in list of commands and associated protocols that gets used by default to decide how to handle a given command. However, if the command is not known to the controller then it presumably assumes it to be a non-data command which then causes protocol mismatch errors if the device ends up requesting data transfer. The new DATA SET MANAGEMENT - Trim command causes this issue since it's a DMA data-out command. Since we should always know best what protocol the command should be using, let's just set the override flag to inform the controller what protocol to use for all non-ATAPI commands with data transfer. Signed-off-by: Robert Hancock Tested-by: Mark Lord Signed-off-by: Jeff Garzik --- drivers/ata/sata_sil24.c | 11 +++++++++++ 1 file changed, 11 insertions(+) diff --git a/drivers/ata/sata_sil24.c b/drivers/ata/sata_sil24.c index 77aa8d7ecec4..e6946fc527d0 100644 --- a/drivers/ata/sata_sil24.c +++ b/drivers/ata/sata_sil24.c @@ -846,6 +846,17 @@ static void sil24_qc_prep(struct ata_queued_cmd *qc) if (!ata_is_atapi(qc->tf.protocol)) { prb = &cb->ata.prb; sge = cb->ata.sge; + if (ata_is_data(qc->tf.protocol)) { + u16 prot = 0; + ctrl = PRB_CTRL_PROTOCOL; + if (ata_is_ncq(qc->tf.protocol)) + prot |= PRB_PROT_NCQ; + if (qc->tf.flags & ATA_TFLAG_WRITE) + prot |= PRB_PROT_WRITE; + else + prot |= PRB_PROT_READ; + prb->prot = cpu_to_le16(prot); + } } else { prb = &cb->atapi.prb; sge = cb->atapi.sge; -- 2.20.1