From 4a6c789b731a095da745d513f9ea0b5531acc9c7 Mon Sep 17 00:00:00 2001 From: Yoni Divinsky Date: Tue, 8 May 2012 14:02:12 +0300 Subject: [PATCH] wl12xx: set the irq polarity before loading the fw The polarity should be set before the firmware is loaded since the firmware touches the same register. Access of the firmware and driver to the same register will cause a collision since there is no exclusion scheme. Signed-off-by: Yoni Divinsky Signed-off-by: Luciano Coelho --- drivers/net/wireless/ti/wl12xx/main.c | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-) diff --git a/drivers/net/wireless/ti/wl12xx/main.c b/drivers/net/wireless/ti/wl12xx/main.c index 774a1b71e84e..a5af2b1ec863 100644 --- a/drivers/net/wireless/ti/wl12xx/main.c +++ b/drivers/net/wireless/ti/wl12xx/main.c @@ -995,7 +995,7 @@ out: static void wl12xx_pre_upload(struct wl1271 *wl) { - u32 tmp; + u32 tmp, polarity; /* write firmware's last address (ie. it's length) to * ACX_EEPROMLESS_IND_REG */ @@ -1015,18 +1015,18 @@ static void wl12xx_pre_upload(struct wl1271 *wl) if (wl->chip.id == CHIP_ID_1283_PG20) wl12xx_top_reg_write(wl, SDIO_IO_DS, HCI_IO_DS_6MA); -} - -static void wl12xx_enable_interrupts(struct wl1271 *wl) -{ - u32 polarity; + /* polarity must be set before the firmware is loaded */ polarity = wl12xx_top_reg_read(wl, OCP_REG_POLARITY); /* We use HIGH polarity, so unset the LOW bit */ polarity &= ~POLARITY_LOW; wl12xx_top_reg_write(wl, OCP_REG_POLARITY, polarity); +} + +static void wl12xx_enable_interrupts(struct wl1271 *wl) +{ wlcore_write_reg(wl, REG_INTERRUPT_MASK, WL1271_ACX_ALL_EVENTS_VECTOR); wlcore_enable_interrupts(wl); -- 2.20.1