From 47415d5452b8945bfbe7e2adb3fa15658b3c3d21 Mon Sep 17 00:00:00 2001 From: Shen Guang Date: Wed, 8 Jan 2014 14:45:42 +0800 Subject: [PATCH] usb:hub set hub->change_bits when over-current happens commit 08d1dec6f4054e3613f32051d9b149d4203ce0d2 upstream. When we are doing compliance test with xHCI, we found that if we enable CONFIG_USB_SUSPEND and plug in a bad device which causes over-current condition to the root port, software will not be noticed. The reason is that current code don't set hub->change_bits in hub_activate() when over-current happens, and then hub_events() will not check the port status because it thinks nothing changed. If CONFIG_USB_SUSPEND is disabled, the interrupt pipe of the hub will report the change and set hub->event_bits, and then hub_events() will check what events happened.In this case over-current can be detected. Signed-off-by: Shen Guang Acked-by: Alan Stern Acked-by: Sarah Sharp Cc: Frans Klaver Signed-off-by: Greg Kroah-Hartman --- drivers/usb/core/hub.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c index 5ff0abc34535..b5d42fee8a84 100644 --- a/drivers/usb/core/hub.c +++ b/drivers/usb/core/hub.c @@ -1165,7 +1165,8 @@ static void hub_activate(struct usb_hub *hub, enum hub_activation_type type) /* Tell khubd to disconnect the device or * check for a new connection */ - if (udev || (portstatus & USB_PORT_STAT_CONNECTION)) + if (udev || (portstatus & USB_PORT_STAT_CONNECTION) || + (portstatus & USB_PORT_STAT_OVERCURRENT)) set_bit(port1, hub->change_bits); } else if (portstatus & USB_PORT_STAT_ENABLE) { -- 2.20.1