From 2a4eebf0c485d8e90bdd2e33e75c4b3b1e1673ac Mon Sep 17 00:00:00 2001 From: Claudiu Manoil Date: Thu, 13 Aug 2015 16:50:37 +0300 Subject: [PATCH] gianfar: Restore link state settings after MAC reset There are some MAC registers that need to be kept in sync with the link state parameters, see adjust_link(). However, after a MAC soft reset default values for these registers are assumed. In some cases (excepting if down/ if up for example) adjust_link() does not see that these values were reset to default because the priv->old* link parameters were left unchanged. So, reset the priv->old* link params as well during a MAC reset to let adjust_link() restore the MAC link settings to the actual link state values. Fixes following case, for example: Setting link to 100M, changing MTU (implies MAC reset), link state remains unchanged to 100M but MAC registers were reset to default (1G) breaking the connectivity w/ the PHY. Closing and re-opening the interface would restore the MAC link parameters to the correct values. Signed-off-by: Claudiu Manoil Signed-off-by: David S. Miller --- drivers/net/ethernet/freescale/gianfar.c | 5 +++++ 1 file changed, 5 insertions(+) diff --git a/drivers/net/ethernet/freescale/gianfar.c b/drivers/net/ethernet/freescale/gianfar.c index 2b7610f341b0..10b3bbbbac8e 100644 --- a/drivers/net/ethernet/freescale/gianfar.c +++ b/drivers/net/ethernet/freescale/gianfar.c @@ -2102,6 +2102,11 @@ int startup_gfar(struct net_device *ndev) /* Start Rx/Tx DMA and enable the interrupts */ gfar_start(priv); + /* force link state update after mac reset */ + priv->oldlink = 0; + priv->oldspeed = 0; + priv->oldduplex = -1; + phy_start(priv->phydev); enable_napi(priv); -- 2.20.1