From 29b7e43c310bdc20d240c7674d9073f6c1c12a3f Mon Sep 17 00:00:00 2001 From: Martin Michlmayr Date: Mon, 4 May 2009 20:58:50 +0200 Subject: [PATCH] sata_mv: use new sata phy register settings for new devices Marvell's new SoC (65 nano) needs different settings for its SATA PHY registers. Tested-by: Martin Michlmayr Signed-off-by: Saeed Bishara Signed-off-by: Jeff Garzik --- drivers/ata/sata_mv.c | 69 +++++++++++++++++++++++++++++++++++++++++-- 1 file changed, 67 insertions(+), 2 deletions(-) diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c index 870dcfd82357..23714aefb825 100644 --- a/drivers/ata/sata_mv.c +++ b/drivers/ata/sata_mv.c @@ -293,6 +293,10 @@ enum { FISCFG_WAIT_DEV_ERR = (1 << 8), /* wait for host on DevErr */ FISCFG_SINGLE_SYNC = (1 << 16), /* SYNC on DMA activation */ + PHY_MODE9_GEN2 = 0x398, + PHY_MODE9_GEN1 = 0x39c, + PHYCFG_OFS = 0x3a0, /* only in 65n devices */ + MV5_PHY_MODE = 0x74, MV5_LTMODE = 0x30, MV5_PHY_CTL = 0x0C, @@ -609,6 +613,8 @@ static int mv_soc_reset_hc(struct mv_host_priv *hpriv, static void mv_soc_reset_flash(struct mv_host_priv *hpriv, void __iomem *mmio); static void mv_soc_reset_bus(struct ata_host *host, void __iomem *mmio); +static void mv_soc_65n_phy_errata(struct mv_host_priv *hpriv, + void __iomem *mmio, unsigned int port); static void mv_reset_pci_bus(struct ata_host *host, void __iomem *mmio); static void mv_reset_channel(struct mv_host_priv *hpriv, void __iomem *mmio, unsigned int port_no); @@ -807,6 +813,14 @@ static const struct mv_hw_ops mv_soc_ops = { .reset_bus = mv_soc_reset_bus, }; +static const struct mv_hw_ops mv_soc_65n_ops = { + .phy_errata = mv_soc_65n_phy_errata, + .enable_leds = mv_soc_enable_leds, + .reset_hc = mv_soc_reset_hc, + .reset_flash = mv_soc_reset_flash, + .reset_bus = mv_soc_reset_bus, +}; + /* * Functions */ @@ -3397,6 +3411,53 @@ static void mv_soc_reset_bus(struct ata_host *host, void __iomem *mmio) return; } +static void mv_soc_65n_phy_errata(struct mv_host_priv *hpriv, + void __iomem *mmio, unsigned int port) +{ + void __iomem *port_mmio = mv_port_base(mmio, port); + u32 reg; + + reg = readl(port_mmio + PHY_MODE3); + reg &= ~(0x3 << 27); /* SELMUPF (bits 28:27) to 1 */ + reg |= (0x1 << 27); + reg &= ~(0x3 << 29); /* SELMUPI (bits 30:29) to 1 */ + reg |= (0x1 << 29); + writel(reg, port_mmio + PHY_MODE3); + + reg = readl(port_mmio + PHY_MODE4); + reg &= ~0x1; /* SATU_OD8 (bit 0) to 0, reserved bit 16 must be set */ + reg |= (0x1 << 16); + writel(reg, port_mmio + PHY_MODE4); + + reg = readl(port_mmio + PHY_MODE9_GEN2); + reg &= ~0xf; /* TXAMP[3:0] (bits 3:0) to 8 */ + reg |= 0x8; + reg &= ~(0x1 << 14); /* TXAMP[4] (bit 14) to 0 */ + writel(reg, port_mmio + PHY_MODE9_GEN2); + + reg = readl(port_mmio + PHY_MODE9_GEN1); + reg &= ~0xf; /* TXAMP[3:0] (bits 3:0) to 8 */ + reg |= 0x8; + reg &= ~(0x1 << 14); /* TXAMP[4] (bit 14) to 0 */ + writel(reg, port_mmio + PHY_MODE9_GEN1); +} + +/** + * soc_is_65 - check if the soc is 65 nano device + * + * Detect the type of the SoC, this is done by reading the PHYCFG_OFS + * register, this register should contain non-zero value and it exists only + * in the 65 nano devices, when reading it from older devices we get 0. + */ +static bool soc_is_65n(struct mv_host_priv *hpriv) +{ + void __iomem *port0_mmio = mv_port_base(hpriv->base, 0); + + if (readl(port0_mmio + PHYCFG_OFS)) + return true; + return false; +} + static void mv_setup_ifcfg(void __iomem *port_mmio, int want_gen2i) { u32 ifcfg = readl(port_mmio + SATA_IFCFG); @@ -3737,7 +3798,10 @@ static int mv_chip_id(struct ata_host *host, unsigned int board_idx) } break; case chip_soc: - hpriv->ops = &mv_soc_ops; + if (soc_is_65n(hpriv)) + hpriv->ops = &mv_soc_65n_ops; + else + hpriv->ops = &mv_soc_ops; hp_flags |= MV_HP_FLAG_SOC | MV_HP_GEN_IIE | MV_HP_ERRATA_60X1C0; break; @@ -3800,7 +3864,8 @@ static int mv_init_host(struct ata_host *host, unsigned int board_idx) n_hc = mv_get_hc_count(host->ports[0]->flags); for (port = 0; port < host->n_ports; port++) - hpriv->ops->read_preamp(hpriv, port, mmio); + if (hpriv->ops->read_preamp) + hpriv->ops->read_preamp(hpriv, port, mmio); rc = hpriv->ops->reset_hc(hpriv, mmio, n_hc); if (rc) -- 2.20.1