From 06c22bd13f4eb55e291d5a31280b2ae5a70ad00d Mon Sep 17 00:00:00 2001 From: Andrew Vasquez Date: Fri, 26 Aug 2005 19:09:00 -0700 Subject: [PATCH] [SCSI] qla2xxx: Correct LED scheme definition. Original implementation used an overloaded bit in the EFI parameters. The correct bit is BIT_4 of the special_options section of NVRAM. Signed-off-by: Andrew Vasquez Signed-off-by: James Bottomley --- drivers/scsi/qla2xxx/qla_def.h | 4 ++-- drivers/scsi/qla2xxx/qla_init.c | 2 +- 2 files changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/scsi/qla2xxx/qla_def.h b/drivers/scsi/qla2xxx/qla_def.h index cdef86e49c6..b7f82b757cb 100644 --- a/drivers/scsi/qla2xxx/qla_def.h +++ b/drivers/scsi/qla2xxx/qla_def.h @@ -914,7 +914,7 @@ typedef struct { * MSB BIT 1 = * MSB BIT 2 = * MSB BIT 3 = - * MSB BIT 4 = + * MSB BIT 4 = LED mode * MSB BIT 5 = enable 50 ohm termination * MSB BIT 6 = Data Rate (2300 only) * MSB BIT 7 = Data Rate (2300 only) @@ -1036,7 +1036,7 @@ typedef struct { * MSB BIT 1 = * MSB BIT 2 = * MSB BIT 3 = - * MSB BIT 4 = + * MSB BIT 4 = LED mode * MSB BIT 5 = enable 50 ohm termination * MSB BIT 6 = Data Rate (2300 only) * MSB BIT 7 = Data Rate (2300 only) diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c index d12255fb938..c619583e646 100644 --- a/drivers/scsi/qla2xxx/qla_init.c +++ b/drivers/scsi/qla2xxx/qla_init.c @@ -1564,7 +1564,7 @@ qla2x00_nvram_config(scsi_qla_host_t *ha) ha->flags.enable_lip_reset = ((nv->host_p[1] & BIT_1) ? 1 : 0); ha->flags.enable_lip_full_login = ((nv->host_p[1] & BIT_2) ? 1 : 0); ha->flags.enable_target_reset = ((nv->host_p[1] & BIT_3) ? 1 : 0); - ha->flags.enable_led_scheme = ((nv->efi_parameters & BIT_3) ? 1 : 0); + ha->flags.enable_led_scheme = (nv->special_options[1] & BIT_4) ? 1 : 0; ha->operating_mode = (icb->add_firmware_options[0] & (BIT_6 | BIT_5 | BIT_4)) >> 4; -- 2.20.1