From: Luca Coelho Date: Mon, 17 Jul 2017 06:15:34 +0000 (+0300) Subject: iwlwifi: remove references to unsupported HW X-Git-Url: https://git.stricted.de/?a=commitdiff_plain;h=fb70d49f2afec87fc570852c2251ffd3117c7373;p=GitHub%2FLineageOS%2Fandroid_kernel_motorola_exynos9610.git iwlwifi: remove references to unsupported HW There are still some references to 3945 and 4965 HW, which were never supported in iwlwifi. These references were inherited from a previous project and are irrelevant here. Additionally, remove some irrelevant references to 5100 HW. Remove all these. Signed-off-by: Luca Coelho --- diff --git a/drivers/net/wireless/intel/iwlwifi/dvm/commands.h b/drivers/net/wireless/intel/iwlwifi/dvm/commands.h index ede47e3c5971..f89736d60a3d 100644 --- a/drivers/net/wireless/intel/iwlwifi/dvm/commands.h +++ b/drivers/net/wireless/intel/iwlwifi/dvm/commands.h @@ -311,11 +311,6 @@ enum { /** * rate_n_flags Tx antenna masks - * 4965 has 2 transmitters - * 5100 has 1 transmitter B - * 5150 has 1 transmitter A - * 5300 has 3 transmitters - * 5350 has 3 transmitters * bit14:16 */ #define RATE_MCS_ANT_POS 14 @@ -1230,7 +1225,6 @@ struct iwl_rx_mpdu_res_start { */ /* - * 4965 uCode updates these Tx attempt count values in host DRAM. * Used for managing Tx retries when expecting block-acks. * Driver should set these fields to 0. */ @@ -1540,7 +1534,7 @@ struct iwl_link_qual_general_params { /* Best single antenna to use for single stream (legacy, SISO). */ u8 single_stream_ant_msk; /* LINK_QUAL_ANT_* */ - /* Best antennas to use for MIMO (unused for 4965, assumes both). */ + /* Best antennas to use for MIMO */ u8 dual_stream_ant_msk; /* LINK_QUAL_ANT_* */ /* diff --git a/drivers/net/wireless/intel/iwlwifi/iwl-csr.h b/drivers/net/wireless/intel/iwlwifi/iwl-csr.h index 560de9de5232..7d468ad7cb6a 100644 --- a/drivers/net/wireless/intel/iwlwifi/iwl-csr.h +++ b/drivers/net/wireless/intel/iwlwifi/iwl-csr.h @@ -169,7 +169,7 @@ /* * CSR Hardware Revision Workaround Register. Indicates hardware rev; - * "step" determines CCK backoff for txpower calculation. Used for 4965 only. + * "step" determines CCK backoff for txpower calculation. * See also CSR_HW_REV register. * Bit fields: * 3-2: 0 = A, 1 = B, 2 = C, 3 = D step diff --git a/drivers/net/wireless/intel/iwlwifi/pcie/trans.c b/drivers/net/wireless/intel/iwlwifi/pcie/trans.c index 439cf424e058..382d7c251066 100644 --- a/drivers/net/wireless/intel/iwlwifi/pcie/trans.c +++ b/drivers/net/wireless/intel/iwlwifi/pcie/trans.c @@ -1842,8 +1842,8 @@ static bool iwl_trans_pcie_grab_nic_access(struct iwl_trans *trans, * These bits say the device is running, and should keep running for * at least a short while (at least as long as MAC_ACCESS_REQ stays 1), * but they do not indicate that embedded SRAM is restored yet; - * 3945 and 4965 have volatile SRAM, and must save/restore contents - * to/from host DRAM when sleeping/waking for power-saving. + * HW with volatile SRAM must save/restore contents to/from + * host DRAM when sleeping/waking for power-saving. * Each direction takes approximately 1/4 millisecond; with this * overhead, it's a good idea to grab and hold MAC_ACCESS_REQUEST if a * series of register accesses are expected (e.g. reading Event Log), @@ -1851,8 +1851,9 @@ static bool iwl_trans_pcie_grab_nic_access(struct iwl_trans *trans, * * CSR_UCODE_DRV_GP1 register bit MAC_SLEEP == 0 indicates that * SRAM is okay/restored. We don't check that here because this call - * is just for hardware register access; but GP1 MAC_SLEEP check is a - * good idea before accessing 3945/4965 SRAM (e.g. reading Event Log). + * is just for hardware register access; but GP1 MAC_SLEEP + * check is a good idea before accessing the SRAM of HW with + * volatile SRAM (e.g. reading Event Log). * * 5000 series and later (including 1000 series) have non-volatile SRAM, * and do not save/restore SRAM when power cycling.