From: Rick Altherr Date: Wed, 15 Feb 2017 06:09:14 +0000 (-0800) Subject: pinctrl: aspeed: Allow disabling Port D and Port E loopback mode X-Git-Url: https://git.stricted.de/?a=commitdiff_plain;h=c825676b0823fd43a4d08bf865f81bb188b51db1;p=GitHub%2Fmoto-9609%2Fandroid_kernel_motorola_exynos9610.git pinctrl: aspeed: Allow disabling Port D and Port E loopback mode Port D and port E GPIO loopback modes are commonly enabled via hardware straps for use with front-panel buttons. When the BMC is powered off or fails to boot, the front-panel buttons are directly connected to the host chipset via the loopback to allow direct power-on and reset control. Once the BMC has booted, the loopback mode must be disabled for the BMC to take over control of host power-on and reset. Disabling these loopback modes requires writing to the hardware strap register which violates the current design of assuming the system designer chose the strap settings for a specific reason and they should be treated as read-only. Only the two bits of the strap register related to these loopback modes are allowed to be written and comments have been added to explain why. Signed-off-by: Rick Altherr Acked-by: Joel Stanley Reviewed-by: Andrew Jeffery Signed-off-by: Linus Walleij --- diff --git a/drivers/pinctrl/aspeed/pinctrl-aspeed.c b/drivers/pinctrl/aspeed/pinctrl-aspeed.c index 76f62bd45f02..5b49952e5fad 100644 --- a/drivers/pinctrl/aspeed/pinctrl-aspeed.c +++ b/drivers/pinctrl/aspeed/pinctrl-aspeed.c @@ -198,9 +198,19 @@ static int aspeed_sig_expr_set(const struct aspeed_sig_expr *expr, * them. This may mean that certain functions cannot be * deconfigured and is the reason we re-evaluate after writing * all descriptor bits. + * + * Port D and port E GPIO loopback modes are the only exception + * as those are commonly used with front-panel buttons to allow + * normal operation of the host when the BMC is powered off or + * fails to boot. Once the BMC has booted, the loopback mode + * must be disabled for the BMC to control host power-on and + * reset. */ - if ((desc->reg == HW_STRAP1 || desc->reg == HW_STRAP2) && - desc->ip == ASPEED_IP_SCU) + if (desc->ip == ASPEED_IP_SCU && desc->reg == HW_STRAP1 && + !(desc->mask & (BIT(21) | BIT(22)))) + continue; + + if (desc->ip == ASPEED_IP_SCU && desc->reg == HW_STRAP2) continue; ret = regmap_update_bits(maps[desc->ip], desc->reg,