From: andrew.vasquez@qlogic.com Date: Sat, 14 Jan 2006 01:05:10 +0000 (-0800) Subject: [SCSI] qla2xxx: Correct excessive delay during LOAD-RISC-RAM mailbox command. X-Git-Url: https://git.stricted.de/?a=commitdiff_plain;h=5998983113c1c9158c1ce66ff26a212aceaf7e5c;p=GitHub%2Fmoto-9609%2Fandroid_kernel_motorola_exynos9610.git [SCSI] qla2xxx: Correct excessive delay during LOAD-RISC-RAM mailbox command. Problem report (against 2.4.x driver) from Jeff Layton : An OEM noticed that the U6 qla2200 driver would hang for around 2 minutes at boot time and then proceed normally. I found that the delay was occurring when loading the new firmware into the card, and was due to a schedule_timeout(10) added to the bottom of the polling loop. Some testing showed that the load ram operation on the card was very quick (on the order of a couple of jiffies), but the sleep in the polling loop was making each operation take around 25-30. The attached patch corrects this by making it skip sleeping during the load ram operation, since I believe we only do that when the module is plugged in. It also skips sleeping if the mbox_int flag got set during the current loop. This corrected the hang on my test setup, and OEM also confirmed that it corrected the problem for them. Signed-off-by: Andrew Vasquez Signed-off-by: James Bottomley --- diff --git a/drivers/scsi/qla2xxx/qla_mbx.c b/drivers/scsi/qla2xxx/qla_mbx.c index f90e68de0a86..3de8fee69fa4 100644 --- a/drivers/scsi/qla2xxx/qla_mbx.c +++ b/drivers/scsi/qla2xxx/qla_mbx.c @@ -196,7 +196,9 @@ qla2x00_mailbox_command(scsi_qla_host_t *ha, mbx_cmd_t *mcp) /* Check for pending interrupts. */ qla2x00_poll(ha); - msleep(10); + if (command != MBC_LOAD_RISC_RAM_EXTENDED && + !ha->flags.mbox_int) + msleep(10); } /* while */ }