From: Ben Greear Date: Mon, 24 Nov 2014 14:22:10 +0000 (+0200) Subject: ath10k: apply chainmask settings to vdev on creation X-Git-Url: https://git.stricted.de/?a=commitdiff_plain;h=5572a95b4b5768187652a346356e39e7542ca6e0;p=GitHub%2Fmoto-9609%2Fandroid_kernel_motorola_exynos9610.git ath10k: apply chainmask settings to vdev on creation It appears it takes more than just setting the hardware's chainmask to make things work well. Without this patch, a vdev would only use 1x1 rates when chainmask was set to 0x3. Setting the 'nss' (number of spatial streams) on the vdev helps the firmware's rate-control algorithm work properly. Signed-off-by: Ben Greear Signed-off-by: Kalle Valo --- diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c index 1245ac8c5c6f..7df23794ecd5 100644 --- a/drivers/net/wireless/ath/ath10k/mac.c +++ b/drivers/net/wireless/ath/ath10k/mac.c @@ -2414,12 +2414,28 @@ static int ath10k_get_antenna(struct ieee80211_hw *hw, u32 *tx_ant, u32 *rx_ant) return 0; } +static void ath10k_check_chain_mask(struct ath10k *ar, u32 cm, const char *dbg) +{ + /* It is not clear that allowing gaps in chainmask + * is helpful. Probably it will not do what user + * is hoping for, so warn in that case. + */ + if (cm == 15 || cm == 7 || cm == 3 || cm == 1 || cm == 0) + return; + + ath10k_warn(ar, "mac %s antenna chainmask may be invalid: 0x%x. Suggested values: 15, 7, 3, 1 or 0.\n", + dbg, cm); +} + static int __ath10k_set_antenna(struct ath10k *ar, u32 tx_ant, u32 rx_ant) { int ret; lockdep_assert_held(&ar->conf_mutex); + ath10k_check_chain_mask(ar, tx_ant, "tx"); + ath10k_check_chain_mask(ar, rx_ant, "rx"); + ar->cfg_tx_chainmask = tx_ant; ar->cfg_rx_chainmask = rx_ant; @@ -2782,6 +2798,17 @@ static int ath10k_config(struct ieee80211_hw *hw, u32 changed) return ret; } +static u32 get_nss_from_chainmask(u16 chain_mask) +{ + if ((chain_mask & 0x15) == 0x15) + return 4; + else if ((chain_mask & 0x7) == 0x7) + return 3; + else if ((chain_mask & 0x3) == 0x3) + return 2; + return 1; +} + /* * TODO: * Figure out how to handle WMI_VDEV_SUBTYPE_P2P_DEVICE, @@ -2914,6 +2941,20 @@ static int ath10k_add_interface(struct ieee80211_hw *hw, goto err_vdev_delete; } + if (ar->cfg_tx_chainmask) { + u16 nss = get_nss_from_chainmask(ar->cfg_tx_chainmask); + + vdev_param = ar->wmi.vdev_param->nss; + ret = ath10k_wmi_vdev_set_param(ar, arvif->vdev_id, vdev_param, + nss); + if (ret) { + ath10k_warn(ar, "failed to set vdev %i chainmask 0x%x, nss %i: %d\n", + arvif->vdev_id, ar->cfg_tx_chainmask, nss, + ret); + goto err_vdev_delete; + } + } + if (arvif->vdev_type == WMI_VDEV_TYPE_AP) { ret = ath10k_peer_create(ar, arvif->vdev_id, vif->addr); if (ret) {