[media] rc: add support for IR LEDs driven through SPI
authorAndi Shyti <andi.shyti@samsung.com>
Fri, 16 Dec 2016 06:12:18 +0000 (04:12 -0200)
committerMauro Carvalho Chehab <mchehab@s-opensource.com>
Mon, 30 Jan 2017 16:21:20 +0000 (14:21 -0200)
The ir-spi is a simple device driver which supports the
connection between an IR LED and the MOSI line of an SPI device.

The driver, indeed, uses the SPI framework to stream the raw data
provided by userspace through an rc character device. The chardev
is handled by the LIRC framework and its functionality basically
provides:

 - write: the driver gets a pulse/space signal and translates it
   to a binary signal that will be streamed to the IR led through
   the SPI framework.
 - set frequency: sets the frequency whith which the data should
   be sent. This is handle with ioctl with the
   LIRC_SET_SEND_CARRIER flag (as per lirc documentation)
 - set duty cycle: this is also handled with ioctl with the
   LIRC_SET_SEND_DUTY_CYCLE flag. The driver handles duty cycles
   of 50%, 60%, 70%, 75%, 80% and 90%, calculated on 16bit data.

The character device is created under /dev/lircX name, where X is
and ID assigned by the LIRC framework.

Example of usage:

        fd = open("/dev/lirc0", O_RDWR);
        if (fd < 0)
                return -1;

        val = 608000;
        ret = ioctl(fd, LIRC_SET_SEND_CARRIER, &val);
        if (ret < 0)
                return -1;

val = 60;
        ret = ioctl(fd, LIRC_SET_SEND_DUTY_CYCLE, &val);
        if (ret < 0)
                return -1;

        n = write(fd, buffer, BUF_LEN);
        if (n < 0 || n != BUF_LEN)
                ret = -1;

        close(fd);

Signed-off-by: Andi Shyti <andi.shyti@samsung.com>
Signed-off-by: Sean Young <sean@mess.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com>
drivers/media/rc/Kconfig
drivers/media/rc/Makefile
drivers/media/rc/ir-spi.c [new file with mode: 0644]

index 629e8ca15ab37ef4f42a3c32cc114269f7f95a07..3351e25d617690ab6ff03b16049e6d3c8cb492c6 100644 (file)
@@ -261,6 +261,15 @@ config IR_REDRAT3
           To compile this driver as a module, choose M here: the
           module will be called redrat3.
 
+config IR_SPI
+       tristate "SPI connected IR LED"
+       depends on SPI && LIRC
+       ---help---
+         Say Y if you want to use an IR LED connected through SPI bus.
+
+         To compile this driver as a module, choose M here: the module will be
+         called ir-spi.
+
 config IR_STREAMZAP
        tristate "Streamzap PC Remote IR Receiver"
        depends on USB_ARCH_HAS_HCD
index 3a984ee301e256c9e9e38c085980ce5cc8740384..938c98b82b2299aa727395839cb48ddeaab38124 100644 (file)
@@ -27,6 +27,7 @@ obj-$(CONFIG_IR_NUVOTON) += nuvoton-cir.o
 obj-$(CONFIG_IR_ENE) += ene_ir.o
 obj-$(CONFIG_IR_REDRAT3) += redrat3.o
 obj-$(CONFIG_IR_RX51) += ir-rx51.o
+obj-$(CONFIG_IR_SPI) += ir-spi.o
 obj-$(CONFIG_IR_STREAMZAP) += streamzap.o
 obj-$(CONFIG_IR_WINBOND_CIR) += winbond-cir.o
 obj-$(CONFIG_RC_LOOPBACK) += rc-loopback.o
diff --git a/drivers/media/rc/ir-spi.c b/drivers/media/rc/ir-spi.c
new file mode 100644 (file)
index 0000000..c8863f3
--- /dev/null
@@ -0,0 +1,199 @@
+/*
+ * Copyright (c) 2016 Samsung Electronics Co., Ltd.
+ * Author: Andi Shyti <andi.shyti@samsung.com>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ *
+ * SPI driven IR LED device driver
+ */
+
+#include <linux/delay.h>
+#include <linux/fs.h>
+#include <linux/module.h>
+#include <linux/mutex.h>
+#include <linux/of_gpio.h>
+#include <linux/regulator/consumer.h>
+#include <linux/spi/spi.h>
+#include <media/rc-core.h>
+
+#define IR_SPI_DRIVER_NAME             "ir-spi"
+
+/* pulse value for different duty cycles */
+#define IR_SPI_PULSE_DC_50             0xff00
+#define IR_SPI_PULSE_DC_60             0xfc00
+#define IR_SPI_PULSE_DC_70             0xf800
+#define IR_SPI_PULSE_DC_75             0xf000
+#define IR_SPI_PULSE_DC_80             0xc000
+#define IR_SPI_PULSE_DC_90             0x8000
+
+#define IR_SPI_DEFAULT_FREQUENCY       38000
+#define IR_SPI_BIT_PER_WORD                8
+#define IR_SPI_MAX_BUFSIZE              4096
+
+struct ir_spi_data {
+       u32 freq;
+       u8 duty_cycle;
+       bool negated;
+
+       u16 tx_buf[IR_SPI_MAX_BUFSIZE];
+       u16 pulse;
+       u16 space;
+
+       struct rc_dev *rc;
+       struct spi_device *spi;
+       struct regulator *regulator;
+};
+
+static int ir_spi_tx(struct rc_dev *dev,
+                    unsigned int *buffer, unsigned int count)
+{
+       int i;
+       int ret;
+       unsigned int len = 0;
+       struct ir_spi_data *idata = dev->priv;
+       struct spi_transfer xfer;
+
+       /* convert the pulse/space signal to raw binary signal */
+       for (i = 0; i < count; i++) {
+               int j;
+               u16 val = ((i + 1) % 2) ? idata->pulse : idata->space;
+
+               if (len + buffer[i] >= IR_SPI_MAX_BUFSIZE)
+                       return -EINVAL;
+
+               /*
+                * the first value in buffer is a pulse, so that 0, 2, 4, ...
+                * contain a pulse duration. On the contrary, 1, 3, 5, ...
+                * contain a space duration.
+                */
+               val = (i % 2) ? idata->space : idata->pulse;
+               for (j = 0; j < buffer[i]; j++)
+                       idata->tx_buf[len++] = val;
+       }
+
+       memset(&xfer, 0, sizeof(xfer));
+
+       xfer.speed_hz = idata->freq;
+       xfer.len = len * sizeof(*idata->tx_buf);
+       xfer.tx_buf = idata->tx_buf;
+
+       ret = regulator_enable(idata->regulator);
+       if (ret)
+               return ret;
+
+       ret = spi_sync_transfer(idata->spi, &xfer, 1);
+       if (ret)
+               dev_err(&idata->spi->dev, "unable to deliver the signal\n");
+
+       regulator_disable(idata->regulator);
+
+       return ret ? ret : count;
+}
+
+static int ir_spi_set_tx_carrier(struct rc_dev *dev, u32 carrier)
+{
+       struct ir_spi_data *idata = dev->priv;
+
+       if (!carrier)
+               return -EINVAL;
+
+       idata->freq = carrier;
+
+       return 0;
+}
+
+static int ir_spi_set_duty_cycle(struct rc_dev *dev, u32 duty_cycle)
+{
+       struct ir_spi_data *idata = dev->priv;
+
+       if (duty_cycle >= 90)
+               idata->pulse = IR_SPI_PULSE_DC_90;
+       else if (duty_cycle >= 80)
+               idata->pulse = IR_SPI_PULSE_DC_80;
+       else if (duty_cycle >= 75)
+               idata->pulse = IR_SPI_PULSE_DC_75;
+       else if (duty_cycle >= 70)
+               idata->pulse = IR_SPI_PULSE_DC_70;
+       else if (duty_cycle >= 60)
+               idata->pulse = IR_SPI_PULSE_DC_60;
+       else
+               idata->pulse = IR_SPI_PULSE_DC_50;
+
+       if (idata->negated) {
+               idata->pulse = ~idata->pulse;
+               idata->space = 0xffff;
+       } else {
+               idata->space = 0;
+       }
+
+       return 0;
+}
+
+static int ir_spi_probe(struct spi_device *spi)
+{
+       int ret;
+       u8 dc;
+       struct ir_spi_data *idata;
+
+       idata = devm_kzalloc(&spi->dev, sizeof(*idata), GFP_KERNEL);
+       if (!idata)
+               return -ENOMEM;
+
+       idata->regulator = devm_regulator_get(&spi->dev, "irda_regulator");
+       if (IS_ERR(idata->regulator))
+               return PTR_ERR(idata->regulator);
+
+       idata->rc = devm_rc_allocate_device(&spi->dev, RC_DRIVER_IR_RAW_TX);
+       if (!idata->rc)
+               return -ENOMEM;
+
+       idata->rc->tx_ir           = ir_spi_tx;
+       idata->rc->s_tx_carrier    = ir_spi_set_tx_carrier;
+       idata->rc->s_tx_duty_cycle = ir_spi_set_duty_cycle;
+       idata->rc->driver_name     = IR_SPI_DRIVER_NAME;
+       idata->rc->priv            = idata;
+       idata->spi                 = spi;
+
+       idata->negated = of_property_read_bool(spi->dev.of_node,
+                                                       "led-active-low");
+       ret = of_property_read_u8(spi->dev.of_node, "duty-cycle", &dc);
+       if (ret)
+               dc = 50;
+
+       /* ir_spi_set_duty_cycle cannot fail,
+        * it returns int to be compatible with the
+        * rc->s_tx_duty_cycle function
+        */
+       ir_spi_set_duty_cycle(idata->rc, dc);
+
+       idata->freq = IR_SPI_DEFAULT_FREQUENCY;
+
+       return devm_rc_register_device(&spi->dev, idata->rc);
+}
+
+static int ir_spi_remove(struct spi_device *spi)
+{
+       return 0;
+}
+
+static const struct of_device_id ir_spi_of_match[] = {
+       { .compatible = "ir-spi-led" },
+       {},
+};
+
+static struct spi_driver ir_spi_driver = {
+       .probe = ir_spi_probe,
+       .remove = ir_spi_remove,
+       .driver = {
+               .name = IR_SPI_DRIVER_NAME,
+               .of_match_table = ir_spi_of_match,
+       },
+};
+
+module_spi_driver(ir_spi_driver);
+
+MODULE_AUTHOR("Andi Shyti <andi.shyti@samsung.com>");
+MODULE_DESCRIPTION("SPI IR LED");
+MODULE_LICENSE("GPL v2");