#define UART_ERRATA_i202_MDR1_ACCESS BIT(0)
#define UART_ERRATA_i291_DMA_FORCEIDLE BIT(1)
-#define DEFAULT_CLK_SPEED 48000000 /* 48Mhz*/
+#define DEFAULT_CLK_SPEED 48000000 /* 48Mhz */
/* SCR register bitmasks */
#define OMAP_UART_SCR_RX_TRIG_GRANU1_MASK (1 << 7)
/* WER = 0x7F
* Enable module level wakeup in WER reg
*/
-#define OMAP_UART_WER_MOD_WKUP 0X7F
+#define OMAP_UART_WER_MOD_WKUP 0x7F
/* Enable XON/XOFF flow control on output */
#define OMAP_UART_SW_TX 0x08
dma_addr_t tx_buf_dma_phys;
unsigned int uart_base;
/*
- * Buffer for rx dma.It is not required for tx because the buffer
+ * Buffer for rx dma. It is not required for tx because the buffer
* comes from port structure.
*/
unsigned char *rx_buf;
int use_dma;
/*
* Some bits in registers are cleared on a read, so they must
- * be saved whenever the register is read but the bits will not
+ * be saved whenever the register is read, but the bits will not
* be immediately processed.
*/
unsigned int lsr_break_flag;