mmc: fix mmc mode selection for HS-DDR and higher
authorChen-Yu Tsai <wens@csie.org>
Sun, 29 May 2016 07:04:42 +0000 (15:04 +0800)
committerUlf Hansson <ulf.hansson@linaro.org>
Thu, 2 Jun 2016 08:39:05 +0000 (10:39 +0200)
When IS_ERR_VALUE was removed from the mmc core code, it was replaced
with a simple not-zero check. This does not work, as the value checked
is the return value for mmc_select_bus_width, which returns the set
bit width on success. This made eMMC modes higher than HS-DDR unusable.

Fix this by checking for a positive return value instead.

Fixes: 287980e49ffc ("remove lots of IS_ERR_VALUE abuses")
Cc: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Chen-Yu Tsai <wens@csie.org>
Acked-by: Hans de Goede <hdegoede@redhat.com>
Reviewed-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
Acked-by: Jaehoon Chung <jh80.chung@samsung.com>
Reviewed-by: Shawn Lin <shawn.lin@rock-chips.com>
Tested-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Tested-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
drivers/mmc/core/mmc.c

index c984321d1881d90ea8b7633abd0c55a605d78502..5d438ad3ee32c994eab11f33c267d7d0d62dbbae 100644 (file)
@@ -1276,7 +1276,7 @@ static int mmc_select_hs200(struct mmc_card *card)
         * switch to HS200 mode if bus width is set successfully.
         */
        err = mmc_select_bus_width(card);
-       if (!err) {
+       if (err >= 0) {
                val = EXT_CSD_TIMING_HS200 |
                      card->drive_strength << EXT_CSD_DRV_STR_SHIFT;
                err = __mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
@@ -1583,7 +1583,7 @@ static int mmc_init_card(struct mmc_host *host, u32 ocr,
        } else if (mmc_card_hs(card)) {
                /* Select the desired bus width optionally */
                err = mmc_select_bus_width(card);
-               if (!err) {
+               if (err >= 0) {
                        err = mmc_select_hs_ddr(card);
                        if (err)
                                goto free_card;