[POWERPC] IPIC: Fix spinlock recursion in set_irq_handler
authorScott Wood <scottwood@freescale.com>
Mon, 23 Oct 2006 16:35:22 +0000 (11:35 -0500)
committerPaul Mackerras <paulus@samba.org>
Wed, 25 Oct 2006 03:49:22 +0000 (13:49 +1000)
This causes ipic_set_irq_type to set the handler directly rather
than call set_irq_handler, which causes spinlock recursion because
the lock is already held when ipic_set_irq_type is called.

I'm also not convinced that ipic_set_irq_type should be changing the
handler at all.  There seem to be several controllers that don't and
several that do.  Those that do would break what appears to be a common
usage of calling set_irq_chip_and_handler followed by set_irq_type, if a
non-standard handler were to be used.  OTOH, irq_create_of_mapping()
doesn't set the handler, but only calls set_irq_type().

This patch gets things working in the spinlock-debugging-enabled case,
but I'm curious as to where the handler setting is ideally supposed to be
done.  I don't see any documentation on set_irq_type() that clarifies
what the semantics are supposed to be.

Signed-off-by: Scott Wood <scottwood@freescale.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
arch/powerpc/sysdev/ipic.c

index bc4d4a7f9657d39c4ae037e39ac6a81d9d9a3444..746f78c153756c29007c2bad272e0d0779926989 100644 (file)
@@ -473,9 +473,9 @@ static int ipic_set_irq_type(unsigned int virq, unsigned int flow_type)
        desc->status |= flow_type & IRQ_TYPE_SENSE_MASK;
        if (flow_type & IRQ_TYPE_LEVEL_LOW)  {
                desc->status |= IRQ_LEVEL;
-               set_irq_handler(virq, handle_level_irq);
+               desc->handle_irq = handle_level_irq;
        } else {
-               set_irq_handler(virq, handle_edge_irq);
+               desc->handle_irq = handle_edge_irq;
        }
 
        /* only EXT IRQ senses are programmable on ipic