};
#define CMD_PACKET_SIZE 64
-/* first command after power on can take around 8 seconds */
-#define CMD_TIMEOUT 15000
+#define CMD_TIMEOUT 100
#define CMD_REPLY_RETRY 5
#define CX82310_MTU 1514
ret = usb_bulk_msg(udev, usb_sndbulkpipe(udev, CMD_EP), buf,
CMD_PACKET_SIZE, &actual_len, CMD_TIMEOUT);
if (ret < 0) {
- dev_err(&dev->udev->dev, "send command %#x: error %d\n",
- cmd, ret);
+ if (cmd != CMD_GET_LINK_STATUS)
+ dev_err(&dev->udev->dev, "send command %#x: error %d\n",
+ cmd, ret);
goto end;
}
buf, CMD_PACKET_SIZE, &actual_len,
CMD_TIMEOUT);
if (ret < 0) {
- dev_err(&dev->udev->dev,
- "reply receive error %d\n", ret);
+ if (cmd != CMD_GET_LINK_STATUS)
+ dev_err(&dev->udev->dev,
+ "reply receive error %d\n",
+ ret);
goto end;
}
if (actual_len > 0)
int ret;
char buf[15];
struct usb_device *udev = dev->udev;
+ u8 link[3];
+ int timeout = 50;
/* avoid ADSL modems - continue only if iProduct is "USB NET CARD" */
if (usb_string(udev, udev->descriptor.iProduct, buf, sizeof(buf)) > 0
if (!dev->partial_data)
return -ENOMEM;
+ /* wait for firmware to become ready (indicated by the link being up) */
+ while (--timeout) {
+ ret = cx82310_cmd(dev, CMD_GET_LINK_STATUS, true, NULL, 0,
+ link, sizeof(link));
+ /* the command can time out during boot - it's not an error */
+ if (!ret && link[0] == 1 && link[2] == 1)
+ break;
+ msleep(500);
+ };
+ if (!timeout) {
+ dev_err(&udev->dev, "firmware not ready in time\n");
+ return -ETIMEDOUT;
+ }
+
/* enable ethernet mode (?) */
ret = cx82310_cmd(dev, CMD_ETHERNET_MODE, true, "\x01", 1, NULL, 0);
if (ret) {