Commit
8c8a777 (ARM: OMAP2+: Add function to read GPMC settings from
device-tree) added a device-tree property "gpmc,device-nand" to indicate
is the GPMC child device is NAND. This commit should have updated the
GPMC NAND documentation (Documentation/devicetree/bindings/mtd/gpmc-nand.txt)
to list the property "gpmc,device-nand" as a required property and also
updated the example. However, this property is redundant and not needed
because the GPMC child device node for NAND is called "nand". Therefore,
remove this property.
Signed-off-by: Jon Hunter <jon-hunter@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
- gpmc,burst-wrap Enables wrap bursting
- gpmc,burst-read Enables read page/burst mode
- gpmc,burst-write Enables write page/burst mode
-- gpmc,device-nand Device is NAND
- gpmc,device-width Total width of device(s) connected to a GPMC
chip-select in bytes. The GPMC supports 8-bit
and 16-bit devices and so this property must be
nand-bus-width = <8>;
ti,nand-ecc-opt = "sw";
- gpmc,device-nand;
gpmc,cs-on-ns = <0>;
gpmc,cs-rd-off-ns = <36>;
gpmc,cs-wr-off-ns = <36>;
if (gpmc_nand_data->of_node) {
gpmc_read_settings_dt(gpmc_nand_data->of_node, &s);
} else {
- s.device_nand = true;
-
/* Enable RD PIN Monitoring Reg */
if (gpmc_nand_data->dev_ready) {
s.wait_on_read = true;
}
}
+ s.device_nand = true;
+
if (gpmc_nand_data->devsize == NAND_BUSWIDTH_16)
s.device_width = GPMC_DEVWIDTH_16BIT;
else
p->sync_read = of_property_read_bool(np, "gpmc,sync-read");
p->sync_write = of_property_read_bool(np, "gpmc,sync-write");
- p->device_nand = of_property_read_bool(np, "gpmc,device-nand");
of_property_read_u32(np, "gpmc,device-width", &p->device_width);
of_property_read_u32(np, "gpmc,mux-add-data", &p->mux_add_data);