Documentation: Update Phonet doc for Pipe controller changes

Updates to Phonet doc for Pipe controller 'connect' socket
implementation and changes related to socket options.

Signed-off-by: Kumar Sanghvi <kumar.sanghvi@stericsson.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/Documentation/networking/phonet.txt b/Documentation/networking/phonet.txt
index 2d9bc2b711fc9030ecf391786034dc0d8648fa0f..24ad2adba6e5fe0d067d7882ce275048e56bd655 100644 (file)
--- a/Documentation/networking/phonet.txt
+++ b/Documentation/networking/phonet.txt
@@ -199,33 +199,29 @@ between itself and a remote pipe-end point (e.g. modem).
 
 The implementation adds socket options at SOL_PNPIPE level:
 
- PNPIPE_CREATE
-       It accepts an integer argument where-in
-               lower order 16 bits: pn_dev and pn_port pair for remote pep.
-               higher order 16 bits: 8 bit pipe-handle
-
-       It sends a PNS_PEP_CONNECT_REQ on sequenced socket itself. On getting
-       PNS_PEP_CONNECT_RESP, it sends PNS_PEP_CONNECT_REQ to remote pep. On
-       getting response from remote pep, it selects the best possible Flow
-       control mechanism supported by remote-pep (modem) and then it sends
-       PNS_PEP_CREATED_IND to the sequenced socket and to the remote pep.
-
-       It then updates the pipe state associated with the sequenced socket to
-       be PIPE_DISABLED.
+ PNPIPE_PIPE_HANDLE
+       It accepts an integer argument for setting value of pipe handle.
 
   PNPIPE_ENABLE accepts one integer value (int). If set to zero, the pipe
     is disabled. If the value is non-zero, the pipe is enabled. If the pipe
     is not (yet) connected, ENOTCONN is error is returned.
 
-   PNPIPE_DESTROY
-       This will send out PNS_PEP_DISCONNECT_REQ on the sequenced socket and
-       the remote pep.
-       It will also update the pipe state associated with the sequenced socket
-       to PIPE_IDLE
+The implementation also adds socket 'connect'. On calling the 'connect', pipe
+will be created between the source socket and the destination, and the pipe
+state will be set to PIPE_DISABLED.
 
 After a pipe has been created and enabled successfully, the Pipe data can be
 exchanged between the host-pep and remote-pep (modem).
 
+User-space would typically follow below sequence with Pipe controller:-
+-socket
+-bind
+-setsockopt for PNPIPE_PIPE_HANDLE
+-connect
+-setsockopt for PNPIPE_ENCAP_IP
+-setsockopt for PNPIPE_ENABLE
+
+
 Authors
 -------