#include <linux/pinctrl/pinconf.h>
/* Since we request GPIOs from ourself */
#include <linux/pinctrl/consumer.h>
-/*
- * For the U8500 archs, use the PRCMU register interface, for the older
- * Nomadik, provide some stubs. The functions using these will only be
- * called on the U8500 series.
- */
-#ifdef CONFIG_ARCH_U8500
-#include <linux/mfd/dbx500-prcmu.h>
-#else
-static inline u32 prcmu_read(unsigned int reg) {
- return 0;
-}
-static inline void prcmu_write(unsigned int reg, u32 value) {}
-static inline void prcmu_write_masked(unsigned int reg, u32 mask, u32 value) {}
-#endif
#include <linux/platform_data/pinctrl-nomadik.h>
#include <asm/mach/irq.h>
u32 lowemi;
};
+/**
+ * struct nmk_pinctrl - state container for the Nomadik pin controller
+ * @dev: containing device pointer
+ * @pctl: corresponding pin controller device
+ * @soc: SoC data for this specific chip
+ * @prcm_base: PRCM register range virtual base
+ */
struct nmk_pinctrl {
struct device *dev;
struct pinctrl_dev *pctl;
const struct nmk_pinctrl_soc_data *soc;
+ void __iomem *prcm_base;
};
static struct nmk_gpio_chip *
dev_dbg(nmk_chip->chip.dev, "%d: clearing interrupt mask\n", gpio);
}
+static void nmk_write_masked(void __iomem *reg, u32 mask, u32 value)
+{
+ u32 val;
+
+ val = readl(reg);
+ val = ((val & ~mask) | (value & mask));
+ writel(val, reg);
+}
+
static void nmk_prcm_altcx_set_mode(struct nmk_pinctrl *npct,
unsigned offset, unsigned alt_num)
{
if (pin_desc->altcx[i].used == true) {
reg = gpiocr_regs[pin_desc->altcx[i].reg_index];
bit = pin_desc->altcx[i].control_bit;
- if (prcmu_read(reg) & BIT(bit)) {
- prcmu_write_masked(reg, BIT(bit), 0);
+ if (readl(npct->prcm_base + reg) & BIT(bit)) {
+ nmk_write_masked(npct->prcm_base + reg, BIT(bit), 0);
dev_dbg(npct->dev,
"PRCM GPIOCR: pin %i: alternate-C%i has been disabled\n",
offset, i+1);
if (pin_desc->altcx[i].used == true) {
reg = gpiocr_regs[pin_desc->altcx[i].reg_index];
bit = pin_desc->altcx[i].control_bit;
- if (prcmu_read(reg) & BIT(bit)) {
- prcmu_write_masked(reg, BIT(bit), 0);
+ if (readl(npct->prcm_base + reg) & BIT(bit)) {
+ nmk_write_masked(npct->prcm_base + reg, BIT(bit), 0);
dev_dbg(npct->dev,
"PRCM GPIOCR: pin %i: alternate-C%i has been disabled\n",
offset, i+1);
bit = pin_desc->altcx[alt_index].control_bit;
dev_dbg(npct->dev, "PRCM GPIOCR: pin %i: alternate-C%i has been selected\n",
offset, alt_index+1);
- prcmu_write_masked(reg, BIT(bit), BIT(bit));
+ nmk_write_masked(npct->prcm_base + reg, BIT(bit), BIT(bit));
}
static void __nmk_config_pin(struct nmk_gpio_chip *nmk_chip, unsigned offset,
if (pin_desc->altcx[i].used == true) {
reg = gpiocr_regs[pin_desc->altcx[i].reg_index];
bit = pin_desc->altcx[i].control_bit;
- if (prcmu_read(reg) & BIT(bit))
+ if (readl(npct->prcm_base + reg) & BIT(bit))
return NMK_GPIO_ALT_C+i+1;
}
}
const struct platform_device_id *platid = platform_get_device_id(pdev);
struct device_node *np = pdev->dev.of_node;
struct nmk_pinctrl *npct;
+ struct resource *res;
unsigned int version = 0;
int i;
if (version == PINCTRL_NMK_DB8540)
nmk_pinctrl_db8540_init(&npct->soc);
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+ if (res) {
+ npct->prcm_base = devm_ioremap(&pdev->dev, res->start,
+ resource_size(res));
+ if (!npct->prcm_base) {
+ dev_err(&pdev->dev,
+ "failed to ioremap PRCM registers\n");
+ return -ENOMEM;
+ }
+ } else {
+ dev_info(&pdev->dev,
+ "No PRCM base, assume no ALT-Cx control is available\n");
+ }
+
/*
* We need all the GPIO drivers to probe FIRST, or we will not be able
* to obtain references to the struct gpio_chip * for them, and we
nmk_pinctrl_desc.pins = npct->soc->pins;
nmk_pinctrl_desc.npins = npct->soc->npins;
npct->dev = &pdev->dev;
+
npct->pctl = pinctrl_register(&nmk_pinctrl_desc, &pdev->dev, npct);
if (!npct->pctl) {
dev_err(&pdev->dev, "could not register Nomadik pinctrl driver\n");