ASoC: use a valid device for dev_err() in Zylonite
authorArnd Bergmann <arnd@arndb.de>
Sat, 1 Oct 2011 20:03:34 +0000 (22:03 +0200)
committerMark Brown <broonie@opensource.wolfsonmicro.com>
Sun, 2 Oct 2011 18:16:52 +0000 (19:16 +0100)
A recent conversion has introduced references to &pdev->dev, which does
not actually exist in all the contexts it's used in.

Replace this with card->dev where necessary, in order to let
the driver build again.

Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Cc: stable@kernel.org
sound/soc/pxa/zylonite.c

index b6445757fc547d953ca23a0da5dd7a3ff1ab8ccf..2b8350b522329253d4d4fda27a7859f68861cc18 100644 (file)
@@ -196,20 +196,20 @@ static int zylonite_probe(struct snd_soc_card *card)
        if (clk_pout) {
                pout = clk_get(NULL, "CLK_POUT");
                if (IS_ERR(pout)) {
-                       dev_err(&pdev->dev, "Unable to obtain CLK_POUT: %ld\n",
+                       dev_err(card->dev, "Unable to obtain CLK_POUT: %ld\n",
                                PTR_ERR(pout));
                        return PTR_ERR(pout);
                }
 
                ret = clk_enable(pout);
                if (ret != 0) {
-                       dev_err(&pdev->dev, "Unable to enable CLK_POUT: %d\n",
+                       dev_err(card->dev, "Unable to enable CLK_POUT: %d\n",
                                ret);
                        clk_put(pout);
                        return ret;
                }
 
-               dev_dbg(&pdev->dev, "MCLK enabled at %luHz\n",
+               dev_dbg(card->dev, "MCLK enabled at %luHz\n",
                        clk_get_rate(pout));
        }
 
@@ -241,7 +241,7 @@ static int zylonite_resume_pre(struct snd_soc_card *card)
        if (clk_pout) {
                ret = clk_enable(pout);
                if (ret != 0)
-                       dev_err(&pdev->dev, "Unable to enable CLK_POUT: %d\n",
+                       dev_err(card->dev, "Unable to enable CLK_POUT: %d\n",
                                ret);
        }