Processor specific macros should be used instead.
Signed-off-by: Tony Lindgren <tony@atomide.com>
/* REVISIT: These should be set dynamically for CONFIG_MULTI_OMAP2 */
#ifdef CONFIG_ARCH_OMAP2420
+#define OMAP_CM_REGADDR OMAP2420_CM_REGADDR
#define OMAP24XX_PRCM_CLKOUT_CTRL OMAP2420_PRCM_CLKOUT_CTRL
#define OMAP24XX_PRCM_CLKEMUL_CTRL OMAP2420_PRCM_CLKEMUL_CTRL
#else
+#define OMAP_CM_REGADDR OMAP2430_CM_REGADDR
#define OMAP24XX_PRCM_CLKOUT_CTRL OMAP2430_PRCM_CLKOUT_CTRL
#define OMAP24XX_PRCM_CLKEMUL_CTRL OMAP2430_PRCM_CLKEMUL_CTRL
#endif
#include "prm.h"
#include "prm-regbits-34xx.h"
+#define OMAP_CM_REGADDR OMAP34XX_CM_REGADDR
+
static unsigned long omap3_dpll_recalc(struct clk *clk);
static unsigned long omap3_clkoutx2_recalc(struct clk *clk);
static void omap3_dpll_allow_idle(struct clk *clk);
#include "prcm-common.h"
-#ifndef __ASSEMBLER__
-#define OMAP_CM_REGADDR(module, reg) \
- IO_ADDRESS(OMAP2_CM_BASE + (module) + (reg))
-#else
#define OMAP2420_CM_REGADDR(module, reg) \
IO_ADDRESS(OMAP2420_CM_BASE + (module) + (reg))
#define OMAP2430_CM_REGADDR(module, reg) \
IO_ADDRESS(OMAP2430_CM_BASE + (module) + (reg))
#define OMAP34XX_CM_REGADDR(module, reg) \
IO_ADDRESS(OMAP3430_CM_BASE + (module) + (reg))
-#endif
/*
* Architecture-specific global CM registers
#define OMAP24XX_SEC_AES_BASE (OMAP24XX_SEC_BASE + 0x6000)
#define OMAP24XX_SEC_PKA_BASE (OMAP24XX_SEC_BASE + 0x8000)
-#if defined(CONFIG_ARCH_OMAP2420)
-
-#define OMAP2_CM_BASE OMAP2420_CM_BASE
-
-#elif defined(CONFIG_ARCH_OMAP2430)
-
-#define OMAP2_CM_BASE OMAP2430_CM_BASE
-
-#endif
-
#endif /* __ASM_ARCH_OMAP24XX_H */
#define OMAP34XX_MAILBOX_BASE (L4_34XX_BASE + 0x94000)
-#if defined(CONFIG_ARCH_OMAP3430)
-
-#define OMAP2_CM_BASE OMAP3430_CM_BASE
-
-#endif
-
#define OMAP34XX_DSP_BASE 0x58000000
#define OMAP34XX_DSP_MEM_BASE (OMAP34XX_DSP_BASE + 0x0)
#define OMAP34XX_DSP_IPI_BASE (OMAP34XX_DSP_BASE + 0x1000000)