cciss: set max scatter gather entries to 32 on P600
authorMike Miller <mike.miller@hp.com>
Wed, 11 Sep 2013 21:20:11 +0000 (14:20 -0700)
committerLinus Torvalds <torvalds@linux-foundation.org>
Wed, 11 Sep 2013 22:56:59 +0000 (15:56 -0700)
At one time we used to set the maximum number of scatter gather elements
on all Smart Array controllers to 32.  At some point in time the
firmware began to write the "appropriate" value for each controller into
the config table.  The cciss driver would then read that and set
h->maxsgentries.

        h->maxsgentries = readl(&(h->cfgtable->MaxSGElements);

On the P600 that value is 544.  Under some workloads a significant
performance reduction may result.  This patch forces the P600 to use
only 32 scatter gather elements.  Other controllers are not affected.

Signed-off-by: Mike Miller <mike.miller@hp.com>
Signed-off-by: Dwight (Bud) Brown <bubrown@redhat.com>
Signed-off-by: Tomas Henzl <thenzl@redhat.com>
Acked-by: Stephen M. Cameron <steve.cameron@hp.com>
Cc: Jens Axboe <axboe@kernel.dk>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
drivers/block/cciss.c

index 62b6c2cc80b5e9d7ef68a7ff84a447e24bb7ade5..d2d95ff5353b08a4f49d1c3da4179090751851bf 100644 (file)
@@ -4257,6 +4257,13 @@ static void cciss_find_board_params(ctlr_info_t *h)
        cciss_get_max_perf_mode_cmds(h);
        h->nr_cmds = h->max_commands - 4 - cciss_tape_cmds;
        h->maxsgentries = readl(&(h->cfgtable->MaxSGElements));
+       /*
+        * The P600 may exhibit poor performnace under some workloads
+        * if we use the value in the configuration table. Limit this
+        * controller to MAXSGENTRIES (32) instead.
+        */
+       if (h->board_id == 0x3225103C)
+               h->maxsgentries = MAXSGENTRIES;
        /*
         * Limit in-command s/g elements to 32 save dma'able memory.
         * Howvever spec says if 0, use 31