#ifdef CONFIG_PM_SLEEP
if (priv->fw->img[IWL_UCODE_WOWLAN].sec[0].len &&
- priv->trans->ops->wowlan_suspend &&
+ priv->trans->ops->d3_suspend &&
+ priv->trans->ops->d3_resume &&
device_can_wakeup(priv->trans->dev)) {
hw->wiphy->wowlan.flags = WIPHY_WOWLAN_MAGIC_PKT |
WIPHY_WOWLAN_DISCONNECT |
if (ret)
goto error;
- iwl_trans_wowlan_suspend(priv->trans);
+ iwl_trans_d3_suspend(priv->trans);
goto out;
#define FH_RSCSR_CHNL0_RBDCB_WPTR_REG (FH_MEM_RSCSR_CHNL0 + 0x008)
#define FH_RSCSR_CHNL0_WPTR (FH_RSCSR_CHNL0_RBDCB_WPTR_REG)
+#define FW_RSCSR_CHNL0_RXDCB_RDPTR_REG (FH_MEM_RSCSR_CHNL0 + 0x00c)
+#define FH_RSCSR_CHNL0_RDPTR FW_RSCSR_CHNL0_RXDCB_RDPTR_REG
/**
* Rx Config/Status Registers (RCSR)
#define FH_MEM_RCSR_CHNL0 (FH_MEM_RCSR_LOWER_BOUND)
#define FH_MEM_RCSR_CHNL0_CONFIG_REG (FH_MEM_RCSR_CHNL0)
+#define FH_MEM_RCSR_CHNL0_RBDCB_WPTR (FH_MEM_RCSR_CHNL0 + 0x8)
+#define FH_MEM_RCSR_CHNL0_FLUSH_RB_REQ (FH_MEM_RCSR_CHNL0 + 0x10)
#define FH_RCSR_CHNL0_RX_CONFIG_RB_TIMEOUT_MSK (0x00000FF0) /* bits 4-11 */
#define FH_RCSR_CHNL0_RX_CONFIG_IRQ_DEST_MSK (0x00001000) /* bits 12 */
#define IWL_MAX_TID_COUNT 8
#define IWL_FRAME_LIMIT 64
+/**
+ * enum iwl_wowlan_status - WoWLAN image/device status
+ * @IWL_D3_STATUS_ALIVE: firmware is still running after resume
+ * @IWL_D3_STATUS_RESET: device was reset while suspended
+ */
+enum iwl_d3_status {
+ IWL_D3_STATUS_ALIVE,
+ IWL_D3_STATUS_RESET,
+};
+
/**
* struct iwl_trans_config - transport configuration
*
* May sleep
* @stop_device:stops the whole device (embedded CPU put to reset)
* May sleep
- * @wowlan_suspend: put the device into the correct mode for WoWLAN during
+ * @d3_suspend: put the device into the correct mode for WoWLAN during
* suspend. This is optional, if not implemented WoWLAN will not be
* supported. This callback may sleep.
+ * @d3_resume: resume the device after WoWLAN, enabling the opmode to
+ * talk to the WoWLAN image to get its status. This is optional, if not
+ * implemented WoWLAN will not be supported. This callback may sleep.
* @send_cmd:send a host command. Must return -ERFKILL if RFkill is asserted.
* If RFkill is asserted in the middle of a SYNC host command, it must
* return -ERFKILL straight away.
void (*fw_alive)(struct iwl_trans *trans, u32 scd_addr);
void (*stop_device)(struct iwl_trans *trans);
- void (*wowlan_suspend)(struct iwl_trans *trans);
+ void (*d3_suspend)(struct iwl_trans *trans);
+ int (*d3_resume)(struct iwl_trans *trans, enum iwl_d3_status *status);
int (*send_cmd)(struct iwl_trans *trans, struct iwl_host_cmd *cmd);
trans->state = IWL_TRANS_NO_FW;
}
-static inline void iwl_trans_wowlan_suspend(struct iwl_trans *trans)
+static inline void iwl_trans_d3_suspend(struct iwl_trans *trans)
+{
+ might_sleep();
+ trans->ops->d3_suspend(trans);
+}
+
+static inline int iwl_trans_d3_resume(struct iwl_trans *trans,
+ enum iwl_d3_status *status)
{
might_sleep();
- trans->ops->wowlan_suspend(trans);
+ return trans->ops->d3_resume(trans, status);
}
static inline int iwl_trans_send_cmd(struct iwl_trans *trans,
struct iwl_rx_cmd_buffer *rxb, int handler_status);
void iwl_trans_pcie_reclaim(struct iwl_trans *trans, int txq_id, int ssn,
struct sk_buff_head *skbs);
+void iwl_trans_pcie_tx_reset(struct iwl_trans *trans);
+
/*****************************************************
* Error handling
******************************************************/
/* Stop Rx DMA */
iwl_write_direct32(trans, FH_MEM_RCSR_CHNL0_CONFIG_REG, 0);
+ /* reset and flush pointers */
+ iwl_write_direct32(trans, FH_MEM_RCSR_CHNL0_RBDCB_WPTR, 0);
+ iwl_write_direct32(trans, FH_MEM_RCSR_CHNL0_FLUSH_RB_REQ, 0);
+ iwl_write_direct32(trans, FH_RSCSR_CHNL0_RDPTR, 0);
/* Reset driver's Rx queue write index */
iwl_write_direct32(trans, FH_RSCSR_CHNL0_RBDCB_WPTR_REG, 0);
{
struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
struct iwl_rxq *rxq = &trans_pcie->rxq;
-
int i, err;
unsigned long flags;
rxq->read = rxq->write = 0;
rxq->write_actual = 0;
rxq->free_count = 0;
+ memset(rxq->rb_stts, 0, sizeof(*rxq->rb_stts));
spin_unlock_irqrestore(&rxq->lock, flags);
iwl_pcie_rx_replenish(trans);
#include "iwl-agn-hw.h"
#include "internal.h"
-static void iwl_pcie_set_pwr_vmain(struct iwl_trans *trans)
+static void iwl_pcie_set_pwr(struct iwl_trans *trans, bool vaux)
{
-/*
- * (for documentation purposes)
- * to set power to V_AUX, do:
-
- if (pci_pme_capable(priv->pci_dev, PCI_D3cold))
- iwl_set_bits_mask_prph(trans, APMG_PS_CTRL_REG,
- APMG_PS_CTRL_VAL_PWR_SRC_VAUX,
- ~APMG_PS_CTRL_MSK_PWR_SRC);
- */
-
- iwl_set_bits_mask_prph(trans, APMG_PS_CTRL_REG,
- APMG_PS_CTRL_VAL_PWR_SRC_VMAIN,
- ~APMG_PS_CTRL_MSK_PWR_SRC);
+ if (vaux && pci_pme_capable(to_pci_dev(trans->dev), PCI_D3cold))
+ iwl_set_bits_mask_prph(trans, APMG_PS_CTRL_REG,
+ APMG_PS_CTRL_VAL_PWR_SRC_VAUX,
+ ~APMG_PS_CTRL_MSK_PWR_SRC);
+ else
+ iwl_set_bits_mask_prph(trans, APMG_PS_CTRL_REG,
+ APMG_PS_CTRL_VAL_PWR_SRC_VMAIN,
+ ~APMG_PS_CTRL_MSK_PWR_SRC);
}
/* PCI registers */
spin_unlock_irqrestore(&trans_pcie->irq_lock, flags);
- iwl_pcie_set_pwr_vmain(trans);
+ iwl_pcie_set_pwr(trans, false);
iwl_op_mode_nic_config(trans->op_mode);
clear_bit(STATUS_RFKILL, &trans_pcie->status);
}
-static void iwl_trans_pcie_wowlan_suspend(struct iwl_trans *trans)
+static void iwl_trans_pcie_d3_suspend(struct iwl_trans *trans)
{
/* let the ucode operate on its own */
iwl_write32(trans, CSR_UCODE_DRV_GP1_SET,
CSR_UCODE_DRV_GP1_BIT_D3_CFG_COMPLETE);
iwl_disable_interrupts(trans);
+ iwl_pcie_disable_ict(trans);
+
iwl_clear_bit(trans, CSR_GP_CNTRL,
CSR_GP_CNTRL_REG_FLAG_MAC_ACCESS_REQ);
+ iwl_clear_bit(trans, CSR_GP_CNTRL,
+ CSR_GP_CNTRL_REG_FLAG_INIT_DONE);
+
+ /*
+ * reset TX queues -- some of their registers reset during S3
+ * so if we don't reset everything here the D3 image would try
+ * to execute some invalid memory upon resume
+ */
+ iwl_trans_pcie_tx_reset(trans);
+
+ iwl_pcie_set_pwr(trans, true);
+}
+
+static int iwl_trans_pcie_d3_resume(struct iwl_trans *trans,
+ enum iwl_d3_status *status)
+{
+ u32 val;
+ int ret;
+
+ iwl_pcie_set_pwr(trans, false);
+
+ val = iwl_read32(trans, CSR_RESET);
+ if (val & CSR_RESET_REG_FLAG_NEVO_RESET) {
+ *status = IWL_D3_STATUS_RESET;
+ return 0;
+ }
+
+ /*
+ * Also enables interrupts - none will happen as the device doesn't
+ * know we're waking it up, only when the opmode actually tells it
+ * after this call.
+ */
+ iwl_pcie_reset_ict(trans);
+
+ iwl_set_bit(trans, CSR_GP_CNTRL, CSR_GP_CNTRL_REG_FLAG_MAC_ACCESS_REQ);
+ iwl_set_bit(trans, CSR_GP_CNTRL, CSR_GP_CNTRL_REG_FLAG_INIT_DONE);
+
+ ret = iwl_poll_bit(trans, CSR_GP_CNTRL,
+ CSR_GP_CNTRL_REG_FLAG_MAC_CLOCK_READY,
+ CSR_GP_CNTRL_REG_FLAG_MAC_CLOCK_READY,
+ 25000);
+ if (ret) {
+ IWL_ERR(trans, "Failed to resume the device (mac ready)\n");
+ return ret;
+ }
+
+ iwl_trans_pcie_tx_reset(trans);
+
+ ret = iwl_pcie_rx_init(trans);
+ if (ret) {
+ IWL_ERR(trans, "Failed to resume the device (RX reset)\n");
+ return ret;
+ }
+
+ iwl_write32(trans, CSR_UCODE_DRV_GP1_CLR,
+ CSR_UCODE_DRV_GP1_BIT_D3_CFG_COMPLETE);
+
+ *status = IWL_D3_STATUS_ALIVE;
+ return 0;
}
static int iwl_trans_pcie_start_hw(struct iwl_trans *trans)
.start_fw = iwl_trans_pcie_start_fw,
.stop_device = iwl_trans_pcie_stop_device,
- .wowlan_suspend = iwl_trans_pcie_wowlan_suspend,
+ .d3_suspend = iwl_trans_pcie_d3_suspend,
+ .d3_resume = iwl_trans_pcie_d3_resume,
.send_cmd = iwl_trans_pcie_send_hcmd,
APMG_PCIDEV_STT_VAL_L1_ACT_DIS);
}
+void iwl_trans_pcie_tx_reset(struct iwl_trans *trans)
+{
+ struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
+ int txq_id;
+
+ for (txq_id = 0; txq_id < trans->cfg->base_params->num_of_queues;
+ txq_id++) {
+ struct iwl_txq *txq = &trans_pcie->txq[txq_id];
+
+ iwl_write_direct32(trans, FH_MEM_CBBC_QUEUE(txq_id),
+ txq->q.dma_addr >> 8);
+ iwl_pcie_txq_unmap(trans, txq_id);
+ txq->q.read_ptr = 0;
+ txq->q.write_ptr = 0;
+ }
+
+ /* Tell NIC where to find the "keep warm" buffer */
+ iwl_write_direct32(trans, FH_KW_MEM_ADDR_REG,
+ trans_pcie->kw.dma >> 4);
+
+ iwl_pcie_tx_start(trans, trans_pcie->scd_base_addr);
+}
+
/*
* iwl_pcie_tx_stop - Stop all Tx DMA channels
*/