Pull MTD updates from David Woodhouse:
- Various cleanups especially in NAND tests
- Add support for NAND flash on BCMA bus
- DT support for sh_flctl and denali NAND drivers
- Kill obsolete/superceded drivers (fortunet, nomadik_nand)
- Fix JFFS2 locking bug in ENOMEM failure path
- New SPI flash chips, as usual
- Support writing in 'reliable mode' for DiskOnChip G4
- Debugfs support in nandsim
* tag 'for-linus-
20121219' of git://git.infradead.org/linux-mtd: (96 commits)
mtd: nand: typo in nand_id_has_period() comments
mtd: nand/gpio: use io{read,write}*_rep accessors
mtd: block2mtd: throttle writes by calling balance_dirty_pages_ratelimited.
mtd: nand: gpmi: reset BCH earlier, too, to avoid NAND startup problems
mtd: nand/docg4: fix and improve read of factory bbt
mtd: nand/docg4: reserve bb marker area in ecclayout
mtd: nand/docg4: add support for writing in reliable mode
mtd: mxc_nand: reorder part_probes to let cmdline override other sources
mtd: mxc_nand: fix unbalanced clk_disable() in error path
mtd: nandsim: Introduce debugfs infrastructure
mtd: physmap_of: error checking to prevent a NULL pointer dereference
mtg: docg3: potential divide by zero in doc_write_oob()
mtd: bcm47xxnflash: writing support
mtd: tests/read: initialize buffer for whole next page
mtd: at91: atmel_nand: return bit flips for the PMECC read_page()
mtd: fix recovery after failed write-buffer operation in cfi_cmdset_0002.c
mtd: nand: onfi need to be probed in 8 bits mode
mtd: nand: add NAND_BUSWIDTH_AUTO to autodetect bus width
mtd: nand: print flash size during detection
mted: nand_wait_ready timeout fix
...
- ti,davinci-nand-buswidth: buswidth 8 or 16
- ti,davinci-nand-use-bbt: use flash based bad block table support.
-Example (enbw_cmc board):
-aemif@60000000 {
- compatible = "ti,davinci-aemif";
- #address-cells = <2>;
- #size-cells = <1>;
- reg = <0x68000000 0x80000>;
- ranges = <2 0 0x60000000 0x02000000
- 3 0 0x62000000 0x02000000
- 4 0 0x64000000 0x02000000
- 5 0 0x66000000 0x02000000
- 6 0 0x68000000 0x02000000>;
- nand@3,0 {
- compatible = "ti,davinci-nand";
- reg = <3 0x0 0x807ff
- 6 0x0 0x8000>;
- #address-cells = <1>;
- #size-cells = <1>;
- ti,davinci-chipselect = <1>;
- ti,davinci-mask-ale = <0>;
- ti,davinci-mask-cle = <0>;
- ti,davinci-mask-chipsel = <0>;
- ti,davinci-ecc-mode = "hw";
- ti,davinci-ecc-bits = <4>;
- ti,davinci-nand-use-bbt;
+ nand device bindings may contain additional sub-nodes describing
+ partitions of the address space. See partition.txt for more detail.
+
- partition@180000 {
- label = "ubifs";
- reg = <0x180000 0x7e80000>;
- };
+Example(da850 EVM ):
+nand_cs3@62000000 {
+ compatible = "ti,davinci-nand";
+ reg = <0x62000000 0x807ff
+ 0x68000000 0x8000>;
+ ti,davinci-chipselect = <1>;
+ ti,davinci-mask-ale = <0>;
+ ti,davinci-mask-cle = <0>;
+ ti,davinci-mask-chipsel = <0>;
+ ti,davinci-ecc-mode = "hw";
+ ti,davinci-ecc-bits = <4>;
+ ti,davinci-nand-use-bbt;
+
++ partition@180000 {
++ label = "ubifs";
++ reg = <0x180000 0x7e80000>;
+ };
};
bootargs = "console=ttyAMA0,115200";
};
- status = "disable";
+ cpufreq {
+ compatible = "st,cpufreq-spear";
+ cpufreq_tbl = < 166000
+ 200000
+ 250000
+ 300000
+ 400000
+ 500000
+ 600000 >;
++ status = "disabled";
+ };
+
ahb {
#address-cells = <1>;
#size-cells = <1>;
0 21 0x4
0 22 0x4
0 23 0x4>;
- st,ale-off = <0x20000>;
- st,cle-off = <0x10000>;
+ st,mode = <2>;
status = "disabled";
};
status = "disabled";
};
- status = "disable";
+ pcm {
+ compatible = "st,pcm-audio";
+ #address-cells = <0>;
+ #size-cells = <0>;
++ status = "disabled";
+ };
+
smi: flash@ea000000 {
compatible = "st,spear600-smi";
#address-cells = <1>;
#include <asm/sizes.h>
#include <asm/mach-types.h>
#include <asm/mach/arch.h>
-#include <asm/mach/irq.h>
#include <asm/mach/flash.h>
#include <asm/mach/time.h>
- #include <mach/fsmc.h>
-
-#include <plat/gpio-nomadik.h>
-#include <plat/mtu.h>
-#include <plat/pincfg.h>
+#include <mach/irqs.h>
#include "cpu-8815.h"
NAND chips (page size 256 byte, erase size 4-8KiB). The IDs
of these chips were reused by later, larger chips.
-config MTD_NAND_AUTCPU12
- tristate "SmartMediaCard on autronix autcpu12 board"
- depends on ARCH_AUTCPU12
- help
- This enables the driver for the autronix autcpu12 board to
- access the SmartMediaCard.
-
config MTD_NAND_DENALI
- depends on PCI
+ tristate "Support Denali NAND controller"
+ help
+ Enable support for the Denali NAND controller. This should be
+ combined with either the PCI or platform drivers to provide device
+ registration.
+
+ config MTD_NAND_DENALI_PCI
tristate "Support Denali NAND controller on Intel Moorestown"
+ depends on PCI && MTD_NAND_DENALI
help
Enable the driver for NAND flash on Intel Moorestown, using the
Denali NAND controller core.
obj-$(CONFIG_MTD_SM_COMMON) += sm_common.o
obj-$(CONFIG_MTD_NAND_CAFE) += cafe_nand.o
-obj-$(CONFIG_MTD_NAND_SPIA) += spia.o
obj-$(CONFIG_MTD_NAND_AMS_DELTA) += ams-delta.o
-obj-$(CONFIG_MTD_NAND_AUTCPU12) += autcpu12.o
obj-$(CONFIG_MTD_NAND_DENALI) += denali.o
+ obj-$(CONFIG_MTD_NAND_DENALI_PCI) += denali_pci.o
+ obj-$(CONFIG_MTD_NAND_DENALI_DT) += denali_dt.o
obj-$(CONFIG_MTD_NAND_AU1550) += au1550nd.o
obj-$(CONFIG_MTD_NAND_BF5XX) += bf5xx_nand.o
obj-$(CONFIG_MTD_NAND_PPCHAMELEONEVB) += ppchameleonevb.o
}
#endif
- static int __devinit mxcnd_probe(struct platform_device *pdev)
-static int __init mxcnd_probe_pdata(struct mxc_nand_host *host)
-{
- struct mxc_nand_platform_data *pdata = host->dev->platform_data;
-
- if (!pdata)
- return -ENODEV;
-
- host->pdata = *pdata;
-
- if (nfc_is_v1()) {
- if (cpu_is_mx21())
- host->devtype_data = &imx21_nand_devtype_data;
- else
- host->devtype_data = &imx27_nand_devtype_data;
- } else if (nfc_is_v21()) {
- host->devtype_data = &imx25_nand_devtype_data;
- } else if (nfc_is_v3_2a()) {
- host->devtype_data = &imx51_nand_devtype_data;
- } else if (nfc_is_v3_2b()) {
- host->devtype_data = &imx53_nand_devtype_data;
- } else
- BUG();
-
- return 0;
-}
-
+ static int mxcnd_probe(struct platform_device *pdev)
{
struct nand_chip *this;
struct mtd_info *mtd;
.owner = THIS_MODULE,
.of_match_table = of_match_ptr(mxcnd_dt_ids),
},
+ .id_table = mxcnd_devtype,
.probe = mxcnd_probe,
- .remove = __devexit_p(mxcnd_remove),
+ .remove = mxcnd_remove,
};
module_platform_driver(mxcnd_driver);
projects / GitHub / moto-9609 / android_kernel_motorola_exynos9610.git / commitdiff