V4L/DVB (9300): pvrusb2: Fix deadlock problem

Fix deadlock problem in 2.6.27 caused by new USB core behavior in
response to a USB device reset request.  With older kernels, the USB
device reset was "in line"; the reset simply took place and the driver
retained its association with the hardware.  However now this reset
triggers a disconnect, and worse still the disconnect callback happens
in the context of the caller who asked for the device reset.  This
results in an attempt by the pvrusb2 driver to recursively take a
mutex it already has, which deadlocks the driver's worker thread.
(Even if the disconnect callback were to happen on a different thread
we'd still have problems however - because while the driver should
survive and correctly disconnect / reconnect, it will then trigger
another device reset during the repeated initialization, which will
then cause another disconect, etc, forever.)  The fix here is simply
to not attempt the device reset (it was of marginal value anyway).

Signed-off-by: Mike Isely <isely@pobox.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>

diff --git a/drivers/media/video/pvrusb2/pvrusb2-hdw.c b/drivers/media/video/pvrusb2/pvrusb2-hdw.c
index 94265bd3d926c1b2a8960ae743a05f962aec75c2..5b81ba469641c89b302a777d9f41f62043609133 100644 (file)
--- a/drivers/media/video/pvrusb2/pvrusb2-hdw.c
+++ b/drivers/media/video/pvrusb2/pvrusb2-hdw.c
@@ -60,7 +60,6 @@ static struct pvr2_hdw *unit_pointers[PVR_NUM] = {[ 0 ... PVR_NUM-1 ] = NULL};
 static DEFINE_MUTEX(pvr2_unit_mtx);
 
 static int ctlchg;
-static int initusbreset = 1;
 static int procreload;
 static int tuner[PVR_NUM] = { [0 ... PVR_NUM-1] = -1 };
 static int tolerance[PVR_NUM] = { [0 ... PVR_NUM-1] = 0 };
@@ -71,8 +70,6 @@ module_param(ctlchg, int, S_IRUGO|S_IWUSR);
 MODULE_PARM_DESC(ctlchg, "0=optimize ctl change 1=always accept new ctl value");
 module_param(init_pause_msec, int, S_IRUGO|S_IWUSR);
 MODULE_PARM_DESC(init_pause_msec, "hardware initialization settling delay");
-module_param(initusbreset, int, S_IRUGO|S_IWUSR);
-MODULE_PARM_DESC(initusbreset, "Do USB reset device on probe");
 module_param(procreload, int, S_IRUGO|S_IWUSR);
 MODULE_PARM_DESC(procreload,
                 "Attempt init failure recovery with firmware reload");
@@ -1967,9 +1964,6 @@ static void pvr2_hdw_setup_low(struct pvr2_hdw *hdw)
        }
        hdw->fw1_state = FW1_STATE_OK;
 
-       if (initusbreset) {
-               pvr2_hdw_device_reset(hdw);
-       }
        if (!pvr2_hdw_dev_ok(hdw)) return;
 
        for (idx = 0; idx < hdw->hdw_desc->client_modules.cnt; idx++) {