i2c: img-scb: add handle for Master halt interrupt

Master halt is issued after each byte of a transaction is processed in
IP version 3.3.
Master halt will stall the bus by holding the SCK line low until the
halt bit in the scb_general_control is cleared.

After the last byte of a transfer is processed we can use the Master
Halt interrupt to facilitate a repeated start transfer without
issuing a stop bit.

Signed-off-by: Sifan Naeem <sifan.naeem@imgtec.com>
Reviewed-by: James Hartley <james.hartley@imgtec.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

diff --git a/drivers/i2c/busses/i2c-img-scb.c b/drivers/i2c/busses/i2c-img-scb.c
index f416010a0b493e0d0c054f923a5ea20241dc6d50..991118f837be31c8412dbb3a1af65958d79e5d4d 100644 (file)
--- a/drivers/i2c/busses/i2c-img-scb.c
+++ b/drivers/i2c/busses/i2c-img-scb.c
@@ -151,6 +151,7 @@
 #define INT_FIFO_EMPTYING              BIT(12)
 #define INT_TRANSACTION_DONE           BIT(15)
 #define INT_SLAVE_EVENT                        BIT(16)
+#define INT_MASTER_HALTED              BIT(17)
 #define INT_TIMING                     BIT(18)
 #define INT_STOP_DETECTED              BIT(19)
 
@@ -177,6 +178,7 @@
                                         INT_FIFO_FULL        | \
                                         INT_FIFO_FILLING     | \
                                         INT_FIFO_EMPTY       | \
+                                        INT_MASTER_HALTED    | \
                                         INT_STOP_DETECTED)
 
 #define INT_ENABLE_MASK_WAITSTOP       (INT_SLAVE_EVENT      | \
@@ -875,18 +877,27 @@ static unsigned int img_i2c_auto(struct img_i2c *i2c,
        }
 
        if (i2c->msg.flags & I2C_M_RD) {
-               if (int_status & INT_FIFO_FULL_FILLING) {
+               if (int_status & (INT_FIFO_FULL_FILLING | INT_MASTER_HALTED)) {
                        img_i2c_read_fifo(i2c);
                        if (i2c->msg.len == 0)
                                return ISR_WAITSTOP;
                }
        } else {
-               if (int_status & INT_FIFO_EMPTY) {
-                       if (i2c->msg.len == 0)
+               if (int_status & (INT_FIFO_EMPTY | INT_MASTER_HALTED)) {
+                       if ((int_status & INT_FIFO_EMPTY) &&
+                           i2c->msg.len == 0)
                                return ISR_WAITSTOP;
                        img_i2c_write_fifo(i2c);
                }
        }
+       if (int_status & INT_MASTER_HALTED) {
+               /*
+                * Release and then enable transaction halt, to
+                * allow only a single byte to proceed.
+                */
+               img_i2c_transaction_halt(i2c, false);
+               img_i2c_transaction_halt(i2c, !i2c->last_msg);
+       }
 
        return 0;
 }