regmap_update_bits(info->regmap, reg, mask, val);
}
- /* Check whether RT8973A is auto swithcing mode or not */
+ /* Check whether RT8973A is auto switching mode or not */
ret = regmap_read(info->regmap, RT8973A_REG_CONTROL1, &data);
if (ret) {
dev_err(info->dev,
#define ADV7183_LETTERBOX_3 0x9D /* Letterbox 3 */
#define ADV7183_CRC_EN 0xB2 /* CRC enable */
#define ADV7183_ADC_SWITCH_1 0xC3 /* ADC switch 1 */
-#define ADV7183_ADC_SWITCH_2 0xC4 /* ADC swithc 2 */
+#define ADV7183_ADC_SWITCH_2 0xC4 /* ADC switch 2 */
#define ADV7183_LETTERBOX_CTRL_1 0xDC /* Letterbox control 1 */
#define ADV7183_LETTERBOX_CTRL_2 0xDD /* Letterbox control 2 */
#define ADV7183_SD_OFFSET_CB 0xE1 /* SD offset Cb */
/* ask to the driver to retune the radio .
* This function can sleep. the driver should ensure
- * the radio has been swithced before return.
+ * the radio has been switched before return.
*/
void (*set_chan)(struct net_device *dev, short ch);
* The syncro version is similar to the start_scan but
* does not return until all channels has been scanned.
* this is called in user context and should sleep,
- * it is called in a work_queue when swithcing to ad-hoc mode
+ * it is called in a work_queue when switching to ad-hoc mode
* or in behalf of iwlist scan when the card is associated
* and root user ask for a scan.
* the function stop_scan should stop both the syncro and
// if((IS_DOT11D_ENABLE(ieee)) && (ieee->state == IEEE80211_NOLINK))
if (ieee->state == IEEE80211_NOLINK)
ieee->current_network.channel = 6;
- /* if not then the state is not linked. Maybe the user swithced to
+ /* if not then the state is not linked. Maybe the user switched to
* ad-hoc mode just after being in monitor mode, or just after
* being very few time in managed mode (so the card have had no
* time to scan all the chans..) or we have just run up the iface
switchs||switches
swith||switch
swithable||switchable
+swithc||switch
+swithced||switched
+swithcing||switching
swithed||switched
swithing||switching
symetric||symmetric