nmk_write_masked(npct->prcm_base + reg, BIT(bit), BIT(bit));
}
-static void __nmk_config_pin(struct nmk_gpio_chip *nmk_chip, unsigned offset,
- pin_cfg_t cfg, bool sleep, unsigned int *slpmregs)
-{
- static const char *afnames[] = {
- [NMK_GPIO_ALT_GPIO] = "GPIO",
- [NMK_GPIO_ALT_A] = "A",
- [NMK_GPIO_ALT_B] = "B",
- [NMK_GPIO_ALT_C] = "C"
- };
- static const char *pullnames[] = {
- [NMK_GPIO_PULL_NONE] = "none",
- [NMK_GPIO_PULL_UP] = "up",
- [NMK_GPIO_PULL_DOWN] = "down",
- [3] /* illegal */ = "??"
- };
- static const char *slpmnames[] = {
- [NMK_GPIO_SLPM_INPUT] = "input/wakeup",
- [NMK_GPIO_SLPM_NOCHANGE] = "no-change/no-wakeup",
- };
-
- int pin = PIN_NUM(cfg);
- int pull = PIN_PULL(cfg);
- int af = PIN_ALT(cfg);
- int slpm = PIN_SLPM(cfg);
- int output = PIN_DIR(cfg);
- int val = PIN_VAL(cfg);
- bool glitch = af == NMK_GPIO_ALT_C;
-
- dev_dbg(nmk_chip->chip.dev, "pin %d [%#lx]: af %s, pull %s, slpm %s (%s%s)\n",
- pin, cfg, afnames[af], pullnames[pull], slpmnames[slpm],
- output ? "output " : "input",
- output ? (val ? "high" : "low") : "");
-
- if (sleep) {
- int slpm_pull = PIN_SLPM_PULL(cfg);
- int slpm_output = PIN_SLPM_DIR(cfg);
- int slpm_val = PIN_SLPM_VAL(cfg);
-
- af = NMK_GPIO_ALT_GPIO;
-
- /*
- * The SLPM_* values are normal values + 1 to allow zero to
- * mean "same as normal".
- */
- if (slpm_pull)
- pull = slpm_pull - 1;
- if (slpm_output)
- output = slpm_output - 1;
- if (slpm_val)
- val = slpm_val - 1;
-
- dev_dbg(nmk_chip->chip.dev, "pin %d: sleep pull %s, dir %s, val %s\n",
- pin,
- slpm_pull ? pullnames[pull] : "same",
- slpm_output ? (output ? "output" : "input") : "same",
- slpm_val ? (val ? "high" : "low") : "same");
- }
-
- if (output)
- __nmk_gpio_make_output(nmk_chip, offset, val);
- else {
- __nmk_gpio_make_input(nmk_chip, offset);
- __nmk_gpio_set_pull(nmk_chip, offset, pull);
- }
-
- __nmk_gpio_set_lowemi(nmk_chip, offset, PIN_LOWEMI(cfg));
-
- /*
- * If the pin is switching to altfunc, and there was an interrupt
- * installed on it which has been lazy disabled, actually mask the
- * interrupt to prevent spurious interrupts that would occur while the
- * pin is under control of the peripheral. Only SKE does this.
- */
- if (af != NMK_GPIO_ALT_GPIO)
- nmk_gpio_disable_lazy_irq(nmk_chip, offset);
-
- /*
- * If we've backed up the SLPM registers (glitch workaround), modify
- * the backups since they will be restored.
- */
- if (slpmregs) {
- if (slpm == NMK_GPIO_SLPM_NOCHANGE)
- slpmregs[nmk_chip->bank] |= BIT(offset);
- else
- slpmregs[nmk_chip->bank] &= ~BIT(offset);
- } else
- __nmk_gpio_set_slpm(nmk_chip, offset, slpm);
-
- __nmk_gpio_set_mode_safe(nmk_chip, offset, af, glitch);
-}
-
/*
* Safe sequence used to switch IOs between GPIO and Alternate-C mode:
* - Save SLPM registers
}
}
-static int __nmk_config_pins(pin_cfg_t *cfgs, int num, bool sleep)
-{
- static unsigned int slpm[NUM_BANKS];
- unsigned long flags;
- bool glitch = false;
- int ret = 0;
- int i;
-
- for (i = 0; i < num; i++) {
- if (PIN_ALT(cfgs[i]) == NMK_GPIO_ALT_C) {
- glitch = true;
- break;
- }
- }
-
- spin_lock_irqsave(&nmk_gpio_slpm_lock, flags);
-
- if (glitch) {
- memset(slpm, 0xff, sizeof(slpm));
-
- for (i = 0; i < num; i++) {
- int pin = PIN_NUM(cfgs[i]);
- int offset = pin % NMK_GPIO_PER_CHIP;
-
- if (PIN_ALT(cfgs[i]) == NMK_GPIO_ALT_C)
- slpm[pin / NMK_GPIO_PER_CHIP] &= ~BIT(offset);
- }
-
- nmk_gpio_glitch_slpm_init(slpm);
- }
-
- for (i = 0; i < num; i++) {
- struct nmk_gpio_chip *nmk_chip;
- int pin = PIN_NUM(cfgs[i]);
-
- nmk_chip = nmk_gpio_chips[pin / NMK_GPIO_PER_CHIP];
- if (!nmk_chip) {
- ret = -EINVAL;
- break;
- }
-
- clk_enable(nmk_chip->clk);
- spin_lock(&nmk_chip->lock);
- __nmk_config_pin(nmk_chip, pin % NMK_GPIO_PER_CHIP,
- cfgs[i], sleep, glitch ? slpm : NULL);
- spin_unlock(&nmk_chip->lock);
- clk_disable(nmk_chip->clk);
- }
-
- if (glitch)
- nmk_gpio_glitch_slpm_restore(slpm);
-
- spin_unlock_irqrestore(&nmk_gpio_slpm_lock, flags);
-
- return ret;
-}
-
-/**
- * nmk_config_pin - configure a pin's mux attributes
- * @cfg: pin confguration
- * @sleep: Non-zero to apply the sleep mode configuration
- * Configures a pin's mode (alternate function or GPIO), its pull up status,
- * and its sleep mode based on the specified configuration. The @cfg is
- * usually one of the SoC specific macros defined in mach/<soc>-pins.h. These
- * are constructed using, and can be further enhanced with, the macros in
- * <linux/platform_data/pinctrl-nomadik.h>
- *
- * If a pin's mode is set to GPIO, it is configured as an input to avoid
- * side-effects. The gpio can be manipulated later using standard GPIO API
- * calls.
- */
-int nmk_config_pin(pin_cfg_t cfg, bool sleep)
-{
- return __nmk_config_pins(&cfg, 1, sleep);
-}
-EXPORT_SYMBOL(nmk_config_pin);
-
-/**
- * nmk_config_pins - configure several pins at once
- * @cfgs: array of pin configurations
- * @num: number of elments in the array
- *
- * Configures several pins using nmk_config_pin(). Refer to that function for
- * further information.
- */
-int nmk_config_pins(pin_cfg_t *cfgs, int num)
-{
- return __nmk_config_pins(cfgs, num, false);
-}
-EXPORT_SYMBOL(nmk_config_pins);
-
-int nmk_config_pins_sleep(pin_cfg_t *cfgs, int num)
-{
- return __nmk_config_pins(cfgs, num, true);
-}
-EXPORT_SYMBOL(nmk_config_pins_sleep);
-
-/**
- * nmk_gpio_set_slpm() - configure the sleep mode of a pin
- * @gpio: pin number
- * @mode: NMK_GPIO_SLPM_INPUT or NMK_GPIO_SLPM_NOCHANGE,
- *
- * This register is actually in the pinmux layer, not the GPIO block itself.
- * The GPIO1B_SLPM register defines the GPIO mode when SLEEP/DEEP-SLEEP
- * mode is entered (i.e. when signal IOFORCE is HIGH by the platform code).
- * Each GPIO can be configured to be forced into GPIO mode when IOFORCE is
- * HIGH, overriding the normal setting defined by GPIO_AFSELx registers.
- * When IOFORCE returns LOW (by software, after SLEEP/DEEP-SLEEP exit),
- * the GPIOs return to the normal setting defined by GPIO_AFSELx registers.
- *
- * If @mode is NMK_GPIO_SLPM_INPUT, the corresponding GPIO is switched to GPIO
- * mode when signal IOFORCE is HIGH (i.e. when SLEEP/DEEP-SLEEP mode is
- * entered) regardless of the altfunction selected. Also wake-up detection is
- * ENABLED.
- *
- * If @mode is NMK_GPIO_SLPM_NOCHANGE, the corresponding GPIO remains
- * controlled by NMK_GPIO_DATC, NMK_GPIO_DATS, NMK_GPIO_DIR, NMK_GPIO_PDIS
- * (for altfunction GPIO) or respective on-chip peripherals (for other
- * altfuncs) when IOFORCE is HIGH. Also wake-up detection DISABLED.
- *
- * Note that enable_irq_wake() will automatically enable wakeup detection.
- */
-int nmk_gpio_set_slpm(int gpio, enum nmk_gpio_slpm mode)
-{
- struct nmk_gpio_chip *nmk_chip;
- unsigned long flags;
-
- nmk_chip = nmk_gpio_chips[gpio / NMK_GPIO_PER_CHIP];
- if (!nmk_chip)
- return -EINVAL;
-
- clk_enable(nmk_chip->clk);
- spin_lock_irqsave(&nmk_gpio_slpm_lock, flags);
- spin_lock(&nmk_chip->lock);
-
- __nmk_gpio_set_slpm(nmk_chip, gpio % NMK_GPIO_PER_CHIP, mode);
-
- spin_unlock(&nmk_chip->lock);
- spin_unlock_irqrestore(&nmk_gpio_slpm_lock, flags);
- clk_disable(nmk_chip->clk);
-
- return 0;
-}
-
-/**
- * nmk_gpio_set_pull() - enable/disable pull up/down on a gpio
- * @gpio: pin number
- * @pull: one of NMK_GPIO_PULL_DOWN, NMK_GPIO_PULL_UP, and NMK_GPIO_PULL_NONE
- *
- * Enables/disables pull up/down on a specified pin. This only takes effect if
- * the pin is configured as an input (either explicitly or by the alternate
- * function).
- *
- * NOTE: If enabling the pull up/down, the caller must ensure that the GPIO is
- * configured as an input. Otherwise, due to the way the controller registers
- * work, this function will change the value output on the pin.
- */
-int nmk_gpio_set_pull(int gpio, enum nmk_gpio_pull pull)
-{
- struct nmk_gpio_chip *nmk_chip;
- unsigned long flags;
-
- nmk_chip = nmk_gpio_chips[gpio / NMK_GPIO_PER_CHIP];
- if (!nmk_chip)
- return -EINVAL;
-
- clk_enable(nmk_chip->clk);
- spin_lock_irqsave(&nmk_chip->lock, flags);
- __nmk_gpio_set_pull(nmk_chip, gpio % NMK_GPIO_PER_CHIP, pull);
- spin_unlock_irqrestore(&nmk_chip->lock, flags);
- clk_disable(nmk_chip->clk);
-
- return 0;
-}
-
-/* Mode functions */
-/**
- * nmk_gpio_set_mode() - set the mux mode of a gpio pin
- * @gpio: pin number
- * @gpio_mode: one of NMK_GPIO_ALT_GPIO, NMK_GPIO_ALT_A,
- * NMK_GPIO_ALT_B, and NMK_GPIO_ALT_C
- *
- * Sets the mode of the specified pin to one of the alternate functions or
- * plain GPIO.
- */
-int nmk_gpio_set_mode(int gpio, int gpio_mode)
-{
- struct nmk_gpio_chip *nmk_chip;
- unsigned long flags;
-
- nmk_chip = nmk_gpio_chips[gpio / NMK_GPIO_PER_CHIP];
- if (!nmk_chip)
- return -EINVAL;
-
- clk_enable(nmk_chip->clk);
- spin_lock_irqsave(&nmk_chip->lock, flags);
- __nmk_gpio_set_mode(nmk_chip, gpio % NMK_GPIO_PER_CHIP, gpio_mode);
- spin_unlock_irqrestore(&nmk_chip->lock, flags);
- clk_disable(nmk_chip->clk);
-
- return 0;
-}
-EXPORT_SYMBOL(nmk_gpio_set_mode);
-
static int __maybe_unused nmk_prcm_gpiocr_get_mode(struct pinctrl_dev *pctldev, int gpio)
{
int i;
projects / GitHub / moto-9609 / android_kernel_motorola_exynos9610.git / commitdiff