tg3: Add EEH support
authorMatt Carlson <mcarlson@broadcom.com>
Mon, 25 Apr 2011 12:42:48 +0000 (12:42 +0000)
committerDavid S. Miller <davem@davemloft.net>
Tue, 26 Apr 2011 07:07:03 +0000 (00:07 -0700)
This patch adds EEH support to the tg3 driver.

Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Reviewed-by: Michael Chan <mchan@broadcom.com>
Reviewed-by: Benjamin Li <benli@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
drivers/net/tg3.c

index fb2139a8070022cba7994ce226293f2d43fa59f8..6bc43ed172b5cfe8feb9983f179e3842762eebaa 100644 (file)
@@ -15395,6 +15395,8 @@ static int __devinit tg3_init_one(struct pci_dev *pdev,
                    pdev->dma_mask == DMA_BIT_MASK(32) ? 32 :
                    ((u64)pdev->dma_mask) == DMA_BIT_MASK(40) ? 40 : 64);
 
+       pci_save_state(pdev);
+
        return 0;
 
 err_out_apeunmap:
@@ -15551,11 +15553,156 @@ static SIMPLE_DEV_PM_OPS(tg3_pm_ops, tg3_suspend, tg3_resume);
 
 #endif /* CONFIG_PM_SLEEP */
 
+/**
+ * tg3_io_error_detected - called when PCI error is detected
+ * @pdev: Pointer to PCI device
+ * @state: The current pci connection state
+ *
+ * This function is called after a PCI bus error affecting
+ * this device has been detected.
+ */
+static pci_ers_result_t tg3_io_error_detected(struct pci_dev *pdev,
+                                             pci_channel_state_t state)
+{
+       struct net_device *netdev = pci_get_drvdata(pdev);
+       struct tg3 *tp = netdev_priv(netdev);
+       pci_ers_result_t err = PCI_ERS_RESULT_NEED_RESET;
+
+       netdev_info(netdev, "PCI I/O error detected\n");
+
+       rtnl_lock();
+
+       if (!netif_running(netdev))
+               goto done;
+
+       tg3_phy_stop(tp);
+
+       tg3_netif_stop(tp);
+
+       del_timer_sync(&tp->timer);
+       tp->tg3_flags2 &= ~TG3_FLG2_RESTART_TIMER;
+
+       /* Want to make sure that the reset task doesn't run */
+       cancel_work_sync(&tp->reset_task);
+       tp->tg3_flags  &= ~TG3_FLAG_TX_RECOVERY_PENDING;
+       tp->tg3_flags2 &= ~TG3_FLG2_RESTART_TIMER;
+
+       netif_device_detach(netdev);
+
+       /* Clean up software state, even if MMIO is blocked */
+       tg3_full_lock(tp, 0);
+       tg3_halt(tp, RESET_KIND_SHUTDOWN, 0);
+       tg3_full_unlock(tp);
+
+done:
+       if (state == pci_channel_io_perm_failure)
+               err = PCI_ERS_RESULT_DISCONNECT;
+       else
+               pci_disable_device(pdev);
+
+       rtnl_unlock();
+
+       return err;
+}
+
+/**
+ * tg3_io_slot_reset - called after the pci bus has been reset.
+ * @pdev: Pointer to PCI device
+ *
+ * Restart the card from scratch, as if from a cold-boot.
+ * At this point, the card has exprienced a hard reset,
+ * followed by fixups by BIOS, and has its config space
+ * set up identically to what it was at cold boot.
+ */
+static pci_ers_result_t tg3_io_slot_reset(struct pci_dev *pdev)
+{
+       struct net_device *netdev = pci_get_drvdata(pdev);
+       struct tg3 *tp = netdev_priv(netdev);
+       pci_ers_result_t rc = PCI_ERS_RESULT_DISCONNECT;
+       int err;
+
+       rtnl_lock();
+
+       if (pci_enable_device(pdev)) {
+               netdev_err(netdev, "Cannot re-enable PCI device after reset.\n");
+               goto done;
+       }
+
+       pci_set_master(pdev);
+       pci_restore_state(pdev);
+       pci_save_state(pdev);
+
+       if (!netif_running(netdev)) {
+               rc = PCI_ERS_RESULT_RECOVERED;
+               goto done;
+       }
+
+       err = tg3_power_up(tp);
+       if (err) {
+               netdev_err(netdev, "Failed to restore register access.\n");
+               goto done;
+       }
+
+       rc = PCI_ERS_RESULT_RECOVERED;
+
+done:
+       rtnl_unlock();
+
+       return rc;
+}
+
+/**
+ * tg3_io_resume - called when traffic can start flowing again.
+ * @pdev: Pointer to PCI device
+ *
+ * This callback is called when the error recovery driver tells
+ * us that its OK to resume normal operation.
+ */
+static void tg3_io_resume(struct pci_dev *pdev)
+{
+       struct net_device *netdev = pci_get_drvdata(pdev);
+       struct tg3 *tp = netdev_priv(netdev);
+       int err;
+
+       rtnl_lock();
+
+       if (!netif_running(netdev))
+               goto done;
+
+       tg3_full_lock(tp, 0);
+       tp->tg3_flags |= TG3_FLAG_INIT_COMPLETE;
+       err = tg3_restart_hw(tp, 1);
+       tg3_full_unlock(tp);
+       if (err) {
+               netdev_err(netdev, "Cannot restart hardware after reset.\n");
+               goto done;
+       }
+
+       netif_device_attach(netdev);
+
+       tp->timer.expires = jiffies + tp->timer_offset;
+       add_timer(&tp->timer);
+
+       tg3_netif_start(tp);
+
+       tg3_phy_start(tp);
+
+done:
+       rtnl_unlock();
+}
+
+static struct pci_error_handlers tg3_err_handler = {
+       .error_detected = tg3_io_error_detected,
+       .slot_reset     = tg3_io_slot_reset,
+       .resume         = tg3_io_resume
+};
+
 static struct pci_driver tg3_driver = {
        .name           = DRV_MODULE_NAME,
        .id_table       = tg3_pci_tbl,
        .probe          = tg3_init_one,
        .remove         = __devexit_p(tg3_remove_one),
+       .err_handler    = &tg3_err_handler,
        .driver.pm      = TG3_PM_OPS,
 };