ARM: STi: DT: Add STiH407 family tsin4 pinctrl configuration

tsin4 can only be configured for serial data transfer. However
depending on board design, two alternate pin configurations
are available. One in pin-controller-front0 and the other in
pin-controller-front1.

pinctrl_tsin4_serial_alt3 is brought out on B2120 reference
design as TSC on NIMA slot of the B2004A daughter board.

Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
Signed-off-by: Maxime Coquelin <maxime.coquelin@st.com>

diff --git a/arch/arm/boot/dts/stih407-pinctrl.dtsi b/arch/arm/boot/dts/stih407-pinctrl.dtsi
index 760f925e1dcc3bd1b72032f208793e2cc2bf112b..50b5bed50d210f8e2ffd9c38cd573b2f3de8e5b1 100644 (file)
--- a/arch/arm/boot/dts/stih407-pinctrl.dtsi
+++ b/arch/arm/boot/dts/stih407-pinctrl.dtsi
@@ -535,6 +535,18 @@
                                        };
                                };
                        };
+
+                       tsin4 {
+                               pinctrl_tsin4_serial_alt3: tsin4_serial_alt3 {
+                                       st,pins {
+                                               DATA7 = <&pio14 6 ALT3 IN SE_NICLK_IO 0 CLK_A>;
+                                               CLKIN = <&pio14 5 ALT3 IN CLKNOTDATA 0 CLK_A>;
+                                               VALID = <&pio14 3 ALT3 IN SE_NICLK_IO 0 CLK_B>;
+                                               ERROR = <&pio14 2 ALT3 IN SE_NICLK_IO 0 CLK_B>;
+                                               PKCLK = <&pio14 4 ALT3 IN SE_NICLK_IO 0 CLK_A>;
+                                       };
+                               };
+                       };
                };
 
                pin-controller-front1 {
@@ -548,6 +560,18 @@
                        interrupts-names = "irqmux";
                        ranges = <0 0x09210000 0x10000>;
 
+                       tsin4 {
+                               pinctrl_tsin4_serial_alt1: tsin4_serial_alt1 {
+                                       st,pins {
+                                               DATA7 = <&pio20 4 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+                                               CLKIN = <&pio20 3 ALT1 IN CLKNOTDATA 0 CLK_A>;
+                                               VALID = <&pio20 1 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+                                               ERROR = <&pio20 0 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+                                               PKCLK = <&pio20 2 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+                                       };
+                               };
+                       };
+
                        pio20: pio@09210000 {
                                gpio-controller;
                                #gpio-cells = <1>;