The pre-1.0 SCPI firmwares are using single __le32 as sensor value,
while the SCPI v1.0 protocol uses two __le32 as sensor values(64bit)
split into 32bit upper and 32bit lower value.
Using an "struct sensor_value" to read the sensor value on a pre-1.0
SCPI firmware gives garbage in the "hi_val" field.
This patch fixes the issue by reading only the lower 32-bit value for
all pre-1.0 SCPI versions.
Suggested-by: Sudeep Holla <Sudeep.Holla@arm.com>
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
[sudeep.holla@arm.com: updated the commit log to reflect the implementation]
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>
ret = scpi_send_message(CMD_SENSOR_VALUE, &id, sizeof(id),
&buf, sizeof(buf));
- if (!ret)
+ if (ret)
+ return ret;
+
+ if (scpi_info->is_legacy)
+ /* only 32-bits supported, hi_val can be junk */
+ *val = le32_to_cpu(buf.lo_val);
+ else
*val = (u64)le32_to_cpu(buf.hi_val) << 32 |
le32_to_cpu(buf.lo_val);
- return ret;
+ return 0;
}
static int scpi_device_get_power_state(u16 dev_id)