pinctrl-aspeed-g5: Never set SCU90[6]

If a pin depending on bit 6 in SCU90 is requested for GPIO, the export
will succeed but changes to the GPIO's value will not be accepted by the
hardware. This is because the pinmux driver has misconfigured the SCU by
writing 1 to the reserved bit.

The description of SCU90[6] from the datasheet is 'Reserved, must keep
at value ”0”'. The fix is to switch pinmux from the bit-flipping macro
to explicitly configuring the .enable and .disable values to zero.

The patch has been tested on an AST2500 EVB.

Fixes: 56e57cb6c07f (pinctrl: Add pinctrl-aspeed-g5 driver)
Reported-by: Uma Yadlapati <yadlapat@us.ibm.com>
Signed-off-by: Andrew Jeffery <andrew@aj.id.au>
Reviewed-by: Joel Stanley <joel@jms.id.au>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

diff --git a/drivers/pinctrl/aspeed/pinctrl-aspeed-g5.c b/drivers/pinctrl/aspeed/pinctrl-aspeed-g5.c
index c8c72e8259d38bc47c83a4222c7311f6e97e7036..87b46390b69597a3299143f3ec4e0ab282475718 100644 (file)
--- a/drivers/pinctrl/aspeed/pinctrl-aspeed-g5.c
+++ b/drivers/pinctrl/aspeed/pinctrl-aspeed-g5.c
@@ -26,7 +26,7 @@
 
 #define ASPEED_G5_NR_PINS 228
 
-#define COND1          SIG_DESC_BIT(SCU90, 6, 0)
+#define COND1          { SCU90, BIT(6), 0, 0 }
 #define COND2          { SCU94, GENMASK(1, 0), 0, 0 }
 
 #define B14 0