regulator: Specify REGULATOR_CHANGE_STATUS for WM835x LED constraints
authorMark Brown <broonie@opensource.wolfsonmicro.com>
Mon, 4 Jan 2010 15:30:54 +0000 (15:30 +0000)
committerLiam Girdwood <lrg@slimlogic.co.uk>
Mon, 1 Feb 2010 13:52:44 +0000 (13:52 +0000)
The WM8350 LED driver needs to be able to enable and disable the
regulators it is using. Previously the core wasn't properly enforcing
status change constraints so the driver was able to function but this
has always been intended to be required.

Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Cc: stable@kernel.org
Signed-off-by: Liam Girdwood <lrg@slimlogic.co.uk>
drivers/regulator/wm8350-regulator.c

index 1bbff099a546af37a1e4e2179ca52f9ffa478962..e7b89e704af671aeabe8ff193022af8048fbd0bc 100644 (file)
@@ -1504,7 +1504,8 @@ int wm8350_register_led(struct wm8350 *wm8350, int lednum, int dcdc, int isink,
        led->isink_init.consumer_supplies = &led->isink_consumer;
        led->isink_init.constraints.min_uA = 0;
        led->isink_init.constraints.max_uA = pdata->max_uA;
-       led->isink_init.constraints.valid_ops_mask = REGULATOR_CHANGE_CURRENT;
+       led->isink_init.constraints.valid_ops_mask
+               = REGULATOR_CHANGE_CURRENT | REGULATOR_CHANGE_STATUS;
        led->isink_init.constraints.valid_modes_mask = REGULATOR_MODE_NORMAL;
        ret = wm8350_register_regulator(wm8350, isink, &led->isink_init);
        if (ret != 0) {
@@ -1517,6 +1518,7 @@ int wm8350_register_led(struct wm8350 *wm8350, int lednum, int dcdc, int isink,
        led->dcdc_init.num_consumer_supplies = 1;
        led->dcdc_init.consumer_supplies = &led->dcdc_consumer;
        led->dcdc_init.constraints.valid_modes_mask = REGULATOR_MODE_NORMAL;
+       led->dcdc_init.constraints.valid_ops_mask =  REGULATOR_CHANGE_STATUS;
        ret = wm8350_register_regulator(wm8350, dcdc, &led->dcdc_init);
        if (ret != 0) {
                platform_device_put(pdev);