MIPS: BMIPS: Document the firmware->kernel DTB interface

Add a new section covering the Generic BMIPS machine type.

Signed-off-by: Kevin Cernekee <cernekee@gmail.com>
Cc: f.fainelli@gmail.com
Cc: jaedon.shin@gmail.com
Cc: abrestic@chromium.org
Cc: tglx@linutronix.de
Cc: jason@lakedaemon.net
Cc: jogo@openwrt.org
Cc: arnd@arndb.de
Cc: computersforpeace@gmail.com
Cc: linux-mips@linux-mips.org
Cc: devicetree@vger.kernel.org
Cc: linux-kernel@vger.kernel.org
Patchwork: https://patchwork.linux-mips.org/patch/8849/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

diff --git a/Documentation/devicetree/booting-without-of.txt b/Documentation/devicetree/booting-without-of.txt
index 77685185cf3b77d465a63dd667b794cb57eea7a9..e49e423268c03c2b4e9713e739d2f9fa482c3e25 100644 (file)
--- a/Documentation/devicetree/booting-without-of.txt
+++ b/Documentation/devicetree/booting-without-of.txt
@@ -15,6 +15,7 @@ Table of Contents
     1) Entry point for arch/arm
     2) Entry point for arch/powerpc
     3) Entry point for arch/x86
+    4) Entry point for arch/mips/bmips
 
   II - The DT block format
     1) Header
@@ -288,6 +289,33 @@ it with special cases.
   or initrd address. It simply holds information which can not be retrieved
   otherwise like interrupt routing or a list of devices behind an I2C bus.
 
+4) Entry point for arch/mips/bmips
+----------------------------------
+
+  Some bootloaders only support a single entry point, at the start of the
+  kernel image.  Other bootloaders will jump to the ELF start address.
+  Both schemes are supported; CONFIG_BOOT_RAW=y and CONFIG_NO_EXCEPT_FILL=y,
+  so the first instruction immediately jumps to kernel_entry().
+
+  Similar to the arch/arm case (b), a DT-aware bootloader is expected to
+  set up the following registers:
+
+         a0 : 0
+
+         a1 : 0xffffffff
+
+         a2 : Physical pointer to the device tree block (defined in chapter
+         II) in RAM.  The device tree can be located anywhere in the first
+         512MB of the physical address space (0x00000000 - 0x1fffffff),
+         aligned on a 64 bit boundary.
+
+  Legacy bootloaders do not use this convention, and they do not pass in a
+  DT block.  In this case, Linux will look for a builtin DTB, selected via
+  CONFIG_DT_*.
+
+  This convention is defined for 32-bit systems only, as there are not
+  currently any 64-bit BMIPS implementations.
+
 II - The DT block format
 ========================