ahci: Turn off DMA engines when there's no device attached

According to section 10.3.1 of the AHCI spec, PxCMD.ST must not be set
unless there's a device attached. Following this saves us a measurable
quantity of power and does not impair hotplug support. Based on a patch
by Kristen Carlson Accardi.

Signed-off-by: Matthew Garrett <mjg@redhat.com>
Cc: Kristen Carlson Accardi <kristen.c.accardi@intel.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

diff --git a/drivers/ata/libahci.c b/drivers/ata/libahci.c
index 38e1b4e9ecf4563bbc25dbbd9a7e16b819e9dd84..3f586ec84a3c1a3bf8c8961e8d538bf0dbc5082c 100644 (file)
--- a/drivers/ata/libahci.c
+++ b/drivers/ata/libahci.c
@@ -437,11 +437,29 @@ static int ahci_scr_write(struct ata_link *link, unsigned int sc_reg, u32 val)
        return -EINVAL;
 }
 
+static int ahci_is_device_present(void __iomem *port_mmio)
+{
+       u8 status = readl(port_mmio + PORT_TFDATA) & 0xff;
+
+       /* Make sure PxTFD.STS.BSY and PxTFD.STS.DRQ are 0 */
+       if (status & (ATA_BUSY | ATA_DRQ))
+               return 0;
+
+       /* Make sure PxSSTS.DET is 3h */
+       status = readl(port_mmio + PORT_SCR_STAT) & 0xf;
+       if (status != 3)
+               return 0;
+       return 1;
+}
+
 void ahci_start_engine(struct ata_port *ap)
 {
        void __iomem *port_mmio = ahci_port_base(ap);
        u32 tmp;
 
+       if (!ahci_is_device_present(port_mmio))
+               return;
+
        /* start DMA */
        tmp = readl(port_mmio + PORT_CMD);
        tmp |= PORT_CMD_START;