Merge tag 'ux500-dt-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw...

From Linus Walleij <linus.walleij@linaro.org>:

Ux500 Device Tree fixes
All are necessary to make a proper DT boot on the v3.9
series:
- IRQ edges.
- Register defines.
- FSMC clock.
- Ethernet clk fixup (one patch to drivers/net ACKed by
  David Miller)
- Proper IOS and regulator voltages for MMCI.
- AB8500 GPIOs restored after they were fixed in the v3.9
  merge window from the pinctrl tree.
- There is also a minor cleanup in the platform code, but it
  is strongly connected to the other patches.

* tag 'ux500-dt-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-stericsson:
  ARM: ux500: allow Snowball access to the AB8500 GPIO pins
  ARM: ux500: enable AB8500 GPIO for HREF
  ARM: ux500: Remove traces of the ios_handler from platform code
  ARM: ux500: Use the GPIO regulator framework for SDI0's 'en' and 'vsel'
  ARM: ux500: Setup correct settling time for the MMCI regulator
  ARM: ux500: Use the correct name when supplying a GPIO enable pin
  ARM: ux500: Specify which IOS regulator to use for MMCI
  ARM: ux500: Specify the ux5x0 MMCI regulator's on/off GPIO as high-enable
  ARM: ux500: Set correct MMCI regulator voltages in the ux5x0 Device Tree
  mmc: mmci: Move ios_handler functionality into the driver
  net/smsc911x: Provide common clock functionality
  clk: ux500: Provide an alias for the SMSC911x Ethernet chip
  clk: ux500: Ensure the FMSC clock is obtainable
  ARM: ux500: Provide a means to obtain the SMSC9115 clock when DT is enabled
  ARM: ux500: Include the PRCMU's Secure Registers in DB8500's DT
  ARM: ux500: Change IRQ from low-to-high edge triggered to high-to-low

Signed-off-by: Arnd Bergmann <arnd@arndb.de>