/* RX, TX, LEDs */
REPLY_TX = 0x1c,
REPLY_LEDS_CMD = 0x48,
- REPLY_TX_LINK_QUALITY_CMD = 0x4e, /* for 4965 and up */
+ REPLY_TX_LINK_QUALITY_CMD = 0x4e,
/* WiMAX coexistence */
- COEX_PRIORITY_TABLE_CMD = 0x5a, /* for 5000 series and up */
+ COEX_PRIORITY_TABLE_CMD = 0x5a,
COEX_MEDIUM_NOTIFICATION = 0x5b,
COEX_EVENT_CMD = 0x5c,
* corresponding to bit (e.g. bit 5 controls TID 5).
* Set modify_mask bit STA_MODIFY_TID_DISABLE_TX to use this field. */
__le16 tid_disable_tx;
-
- __le16 rate_n_flags; /* 3945 only */
+ __le16 legacy_reserved;
/* TID for which to add block-ack support.
* Set modify_mask bit STA_MODIFY_ADDBA_TID_MSK to use this field. */
*
* uCode handles retrying Tx when an ACK is expected but not received.
* This includes trying lower data rates than the one requested in the Tx
- * command, as set up by the REPLY_RATE_SCALE (for 3945) or
- * REPLY_TX_LINK_QUALITY_CMD (agn).
+ * command, as set up by the REPLY_TX_LINK_QUALITY_CMD (agn).
*
* Driver sets up transmit power for various rates via REPLY_TX_PWR_TABLE_CMD.
* This command must be executed after every RXON command, before Tx can occur.
* 1: Use RTS/CTS protocol or CTS-to-self if spec allows it
* before this frame. if CTS-to-self required check
* RXON_FLG_SELF_CTS_EN status.
- * unused in 3945/4965, used in 5000 series and after
*/
#define TX_CMD_FLG_PROT_REQUIRE_MSK cpu_to_le32(1 << 0)
-/*
- * 1: Use Request-To-Send protocol before this frame.
- * Mutually exclusive vs. TX_CMD_FLG_CTS_MSK.
- * used in 3945/4965, unused in 5000 series and after
- */
-#define TX_CMD_FLG_RTS_MSK cpu_to_le32(1 << 1)
-
-/*
- * 1: Transmit Clear-To-Send to self before this frame.
- * Driver should set this for AUTH/DEAUTH/ASSOC-REQ/REASSOC mgmnt frames.
- * Mutually exclusive vs. TX_CMD_FLG_RTS_MSK.
- * used in 3945/4965, unused in 5000 series and after
- */
-#define TX_CMD_FLG_CTS_MSK cpu_to_le32(1 << 2)
-
/* 1: Expect ACK from receiving station
* 0: Don't expect ACK (MAC header's duration field s/b 0)
* Set this for unicast frames, but not broadcast/multicast. */
* Set when Txing a block-ack request frame. Also set TX_CMD_FLG_ACK_MSK. */
#define TX_CMD_FLG_IMM_BA_RSP_MASK cpu_to_le32(1 << 6)
-/*
- * 1: Frame requires full Tx-Op protection.
- * Set this if either RTS or CTS Tx Flag gets set.
- * used in 3945/4965, unused in 5000 series and after
- */
-#define TX_CMD_FLG_FULL_TXOP_PROT_MSK cpu_to_le32(1 << 7)
-
-/* Tx antenna selection field; used only for 3945, reserved (0) for agn devices.
- * Set field to "0" to allow 3945 uCode to select antenna (normal usage). */
+/* Tx antenna selection field; reserved (0) for agn devices. */
#define TX_CMD_FLG_ANT_SEL_MSK cpu_to_le32(0xf00)
-#define TX_CMD_FLG_ANT_A_MSK cpu_to_le32(1 << 8)
-#define TX_CMD_FLG_ANT_B_MSK cpu_to_le32(1 << 9)
/* 1: Ignore Bluetooth priority for this frame.
* 0: Delay Tx until Bluetooth device is done (normal usage). */
__le64 bitmap;
__le16 scd_flow;
__le16 scd_ssn;
- /* following only for 5000 series and up */
u8 txed; /* number of frames sent */
u8 txed_2_done; /* number of frames acked */
} __packed;
/*
* REPLY_TX_LINK_QUALITY_CMD = 0x4e (command, has simple generic response)
*
- * For agn devices only; 3945 uses REPLY_RATE_SCALE.
+ * For agn devices
*
* Each station in the agn device's internal station table has its own table
* of 16
/*
* REPLY_BT_CONFIG = 0x9b (command, has simple generic response)
*
- * 3945 and agn devices support hardware handshake with Bluetooth device on
+ * agn devices support hardware handshake with Bluetooth device on
* same platform. Bluetooth device alerts wireless device when it will Tx;
* wireless device can delay or kill its own Tx to accommodate.
*/
struct iwl_powertable_cmd {
__le16 flags;
- u8 keep_alive_seconds; /* 3945 reserved */
- u8 debug_flags; /* 3945 reserved */
+ u8 keep_alive_seconds;
+ u8 debug_flags;
__le32 rx_data_timeout;
__le32 tx_data_timeout;
__le32 sleep_interval[IWL_POWER_VEC_SIZE];
/**
* struct iwl_ssid_ie - directed scan network information element
*
- * Up to 20 of these may appear in REPLY_SCAN_CMD (Note: Only 4 are in
- * 3945 SCAN api), selected by "type" bit field in struct iwl_scan_channel;
- * each channel may select different ssids from among the 20 (4) entries.
+ * Up to 20 of these may appear in REPLY_SCAN_CMD,
+ * selected by "type" bit field in struct iwl_scan_channel;
+ * each channel may select different ssids from among the 20 entries.
* SSID IEs get transmitted in reverse order of entry.
*/
struct iwl_ssid_ie {
u8 ssid[32];
} __packed;
-#define PROBE_OPTION_MAX_3945 4
#define PROBE_OPTION_MAX 20
#define TX_CMD_LIFE_TIME_INFINITE cpu_to_le32(0xFFFFFFFF)
#define IWL_GOOD_CRC_TH_DISABLED 0
* channel */
__le32 suspend_time; /* pause scan this long (in "extended beacon
* format") when returning to service chnl:
- * 3945; 31:24 # beacons, 19:0 additional usec,
- * 4965; 31:22 # beacons, 21:0 additional usec.
*/
__le32 flags; /* RXON_FLG_* */
__le32 filter_flags; /* RXON_FILTER_* */
struct statistics_general_common {
__le32 temperature; /* radio temperature */
- __le32 temperature_m; /* for 5000 and up, this is radio voltage */
+ __le32 temperature_m; /* radio voltage */
struct statistics_dbg dbg;
__le32 sleep_time;
__le32 slots_out;