can: sja1000: clear interrupts on start
authorMirza Krak <mirza.krak@hostmobility.com>
Tue, 10 Nov 2015 13:59:34 +0000 (14:59 +0100)
committerMarc Kleine-Budde <mkl@pengutronix.de>
Mon, 23 Nov 2015 08:35:21 +0000 (09:35 +0100)
According to SJA1000 data sheet error-warning (EI) interrupt is not
cleared by setting the controller in to reset-mode.

Then if we have the following case:
- system is suspended (echo mem > /sys/power/state) and SJA1000 is left
  in operating state
- A bus error condition occurs which activates EI interrupt, system is
  still suspended which means EI interrupt will be not be handled nor
  cleared.

If the above two events occur, on resume there is no way to return the
SJA1000 to operating state, except to cycle power to it.

By simply reading the IR register on start we will clear any previous
conditions that could be present.

Signed-off-by: Mirza Krak <mirza.krak@hostmobility.com>
Reported-by: Christian Magnusson <Christian.Magnusson@semcon.com>
Cc: linux-stable <stable@vger.kernel.org>
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
drivers/net/can/sja1000/sja1000.c

index 7b92e911a6168badb3e30f8fc55b2e6fdd0f61dc..f10834be48a5c822a8158d695031deb6450a90e1 100644 (file)
@@ -218,6 +218,9 @@ static void sja1000_start(struct net_device *dev)
        priv->write_reg(priv, SJA1000_RXERR, 0x0);
        priv->read_reg(priv, SJA1000_ECC);
 
+       /* clear interrupt flags */
+       priv->read_reg(priv, SJA1000_IR);
+
        /* leave reset mode */
        set_normal_mode(dev);
 }