IP_MULTICAST_IF fails if sk_bound_dev_if is already set and the new index
does not match it. e.g.,
ntpd[15381]: setsockopt IP_MULTICAST_IF 192.168.1.23 fails: Invalid argument
Relax the check in setsockopt to allow setting mc_index to an L3 slave if
sk_bound_dev_if points to an L3 master.
Make a similar change for IPv6. In this case change the device lookup to
take the rcu_read_lock avoiding a refcnt. The rcu lock is also needed for
the lookup of a potential L3 master device.
This really only silences a setsockopt failure since uses of mc_index are
secondary to sk_bound_dev_if if it is set. In both cases, if either index
is an L3 slave or master, lookups are directed to the same FIB table so
relaxing the check at setsockopt time causes no harm.
Patch is based on a suggested change by Darwin for a problem noted in
their code base.
Suggested-by: Darwin Dingel <darwin.dingel@alliedtelesis.co.nz>
Signed-off-by: David Ahern <dsa@cumulusnetworks.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
{
struct ip_mreqn mreq;
struct net_device *dev = NULL;
+ int midx;
if (sk->sk_type == SOCK_STREAM)
goto e_inval;
err = -EADDRNOTAVAIL;
if (!dev)
break;
+
+ midx = l3mdev_master_ifindex(dev);
+
dev_put(dev);
err = -EINVAL;
if (sk->sk_bound_dev_if &&
- mreq.imr_ifindex != sk->sk_bound_dev_if)
+ mreq.imr_ifindex != sk->sk_bound_dev_if &&
+ (!midx || midx != sk->sk_bound_dev_if))
break;
inet->mc_index = mreq.imr_ifindex;
if (val) {
struct net_device *dev;
+ int midx;
- if (sk->sk_bound_dev_if && sk->sk_bound_dev_if != val)
- goto e_inval;
+ rcu_read_lock();
- dev = dev_get_by_index(net, val);
+ dev = dev_get_by_index_rcu(net, val);
if (!dev) {
+ rcu_read_unlock();
retv = -ENODEV;
break;
}
- dev_put(dev);
+ midx = l3mdev_master_ifindex_rcu(dev);
+
+ rcu_read_unlock();
+
+ if (sk->sk_bound_dev_if &&
+ sk->sk_bound_dev_if != val &&
+ (!midx || midx != sk->sk_bound_dev_if))
+ goto e_inval;
}
np->mcast_oif = val;
retv = 0;