u32 val = 0;
/* adjust timeout for emulation/FPGA */
- count = NVRAM_TIMEOUT_COUNT;
+ count = BNX2X_NVRAM_TIMEOUT_COUNT;
if (CHIP_REV_IS_SLOW(bp))
count *= 100;
u32 val = 0;
/* adjust timeout for emulation/FPGA */
- count = NVRAM_TIMEOUT_COUNT;
+ count = BNX2X_NVRAM_TIMEOUT_COUNT;
if (CHIP_REV_IS_SLOW(bp))
count *= 100;
REG_WR(bp, MCP_REG_MCPR_NVM_COMMAND, cmd_flags);
/* adjust timeout for emulation/FPGA */
- count = NVRAM_TIMEOUT_COUNT;
+ count = BNX2X_NVRAM_TIMEOUT_COUNT;
if (CHIP_REV_IS_SLOW(bp))
count *= 100;
REG_WR(bp, MCP_REG_MCPR_NVM_COMMAND, cmd_flags);
/* adjust timeout for emulation/FPGA */
- count = NVRAM_TIMEOUT_COUNT;
+ count = BNX2X_NVRAM_TIMEOUT_COUNT;
if (CHIP_REV_IS_SLOW(bp))
count *= 100;
while ((written_so_far < buf_size) && (rc == 0)) {
if (written_so_far == (buf_size - sizeof(u32)))
cmd_flags |= MCPR_NVM_COMMAND_LAST;
- else if (((offset + 4) % NVRAM_PAGE_SIZE) == 0)
+ else if (((offset + 4) % BNX2X_NVRAM_PAGE_SIZE) == 0)
cmd_flags |= MCPR_NVM_COMMAND_LAST;
- else if ((offset % NVRAM_PAGE_SIZE) == 0)
+ else if ((offset % BNX2X_NVRAM_PAGE_SIZE) == 0)
cmd_flags |= MCPR_NVM_COMMAND_FIRST;
memcpy(&val, data_buf, 4);
offset++;
#endif
for_each_eth_queue(bp, i)
- synchronize_irq(bp->msix_table[i + offset].vector);
+ synchronize_irq(bp->msix_table[offset++].vector);
} else
synchronize_irq(bp->pdev->irq);
SHMEM_WR(bp, func_mb[mb_idx].drv_mb_param, param);
SHMEM_WR(bp, func_mb[mb_idx].drv_mb_header, (command | seq));
- DP(BNX2X_MSG_MCP, "wrote command (%x) to FW MB\n", (command | seq));
+ DP(BNX2X_MSG_MCP, "wrote command (%x) to FW MB param 0x%08x\n",
+ (command | seq), param);
do {
/* let the FW do it's magic ... */
}
val = REG_RD(bp, MCP_REG_MCPR_NVM_CFG4);
- bp->common.flash_size = (NVRAM_1MB_SIZE <<
+ bp->common.flash_size = (BNX2X_NVRAM_1MB_SIZE <<
(val & MCPR_NVM_CFG4_FLASH_SIZE));
BNX2X_DEV_INFO("flash_size 0x%x (%d)\n",
bp->common.flash_size, bp->common.flash_size);
(ADVERTISED_10baseT_Full |
ADVERTISED_TP);
} else {
- BNX2X_ERROR("NVRAM config error. "
+ BNX2X_ERR("NVRAM config error. "
"Invalid link_config 0x%x"
" speed_cap_mask 0x%x\n",
link_config,
(ADVERTISED_10baseT_Half |
ADVERTISED_TP);
} else {
- BNX2X_ERROR("NVRAM config error. "
+ BNX2X_ERR("NVRAM config error. "
"Invalid link_config 0x%x"
" speed_cap_mask 0x%x\n",
link_config,
(ADVERTISED_100baseT_Full |
ADVERTISED_TP);
} else {
- BNX2X_ERROR("NVRAM config error. "
+ BNX2X_ERR("NVRAM config error. "
"Invalid link_config 0x%x"
" speed_cap_mask 0x%x\n",
link_config,
(ADVERTISED_100baseT_Half |
ADVERTISED_TP);
} else {
- BNX2X_ERROR("NVRAM config error. "
+ BNX2X_ERR("NVRAM config error. "
"Invalid link_config 0x%x"
" speed_cap_mask 0x%x\n",
link_config,
(ADVERTISED_1000baseT_Full |
ADVERTISED_TP);
} else {
- BNX2X_ERROR("NVRAM config error. "
+ BNX2X_ERR("NVRAM config error. "
"Invalid link_config 0x%x"
" speed_cap_mask 0x%x\n",
link_config,
(ADVERTISED_2500baseX_Full |
ADVERTISED_TP);
} else {
- BNX2X_ERROR("NVRAM config error. "
+ BNX2X_ERR("NVRAM config error. "
"Invalid link_config 0x%x"
" speed_cap_mask 0x%x\n",
link_config,
(ADVERTISED_10000baseT_Full |
ADVERTISED_FIBRE);
} else {
- BNX2X_ERROR("NVRAM config error. "
+ BNX2X_ERR("NVRAM config error. "
"Invalid link_config 0x%x"
" speed_cap_mask 0x%x\n",
link_config,
break;
default:
- BNX2X_ERROR("NVRAM config error. "
- "BAD link speed link_config 0x%x\n",
- link_config);
+ BNX2X_ERR("NVRAM config error. "
+ "BAD link speed link_config 0x%x\n",
+ link_config);
bp->link_params.req_line_speed[idx] =
SPEED_AUTO_NEG;
bp->port.advertising[idx] =
bp->mf_config[vn] = MF_CFG_RD(bp,
func_mf_config[func].config);
} else
- DP(NETIF_MSG_PROBE, "illegal OV for "
- "SD\n");
+ BNX2X_DEV_INFO("illegal OV for SD\n");
break;
default:
/* Unknown configuration: reset mf_config */
bp->mf_config[vn] = 0;
- DP(NETIF_MSG_PROBE, "Unknown MF mode 0x%x\n",
- val);
+ BNX2X_DEV_INFO("unkown MF mode 0x%x\n", val);
}
}
struct bnx2x *bp = netdev_priv(dev);
if (bp->recovery_state != BNX2X_RECOVERY_DONE) {
- printk(KERN_ERR "Handling parity error recovery. "
- "Try again later\n");
+ netdev_err(bp->dev, "Handling parity error recovery. "
+ "Try again later\n");
return;
}