wlcore: allow only the lowest OFDM rate for p2p setup frames

The IEEE80211_TX_CTL_NO_CCK_RATE flag is only set for mgmt packets
transmitted during p2p connection setup. Make sure to use the lowest
OFDM rate guarantee the peer always hears us.
Change the p2p rate policy to contain only the 6mpbs rate to acheive
this effect.

Signed-off-by: Arik Nemtsov <arik@wizery.com>
Signed-off-by: Luciano Coelho <luca@coelho.fi>

diff --git a/drivers/net/wireless/ti/wlcore/conf.h b/drivers/net/wireless/ti/wlcore/conf.h
index d77224f2ac6bcbccfa6377f85c49a620a8fd2234..9e40760bafe17b43121585d63bacfaa1925611b3 100644 (file)
--- a/drivers/net/wireless/ti/wlcore/conf.h
+++ b/drivers/net/wireless/ti/wlcore/conf.h
@@ -412,8 +412,7 @@ struct conf_rx_settings {
 #define CONF_TX_RATE_RETRY_LIMIT       10
 
 /* basic rates for p2p operations (probe req/resp, etc.) */
-#define CONF_TX_RATE_MASK_BASIC_P2P    (CONF_HW_BIT_RATE_6MBPS | \
-       CONF_HW_BIT_RATE_12MBPS | CONF_HW_BIT_RATE_24MBPS)
+#define CONF_TX_RATE_MASK_BASIC_P2P    CONF_HW_BIT_RATE_6MBPS
 
 /*
  * Rates supported for data packets when operating as AP. Note the absence