V4L/DVB (9421): We must wait for the PLL to stabilize

Thanks to Peter for the in depth explanation

Signed-off-by: Manu Abraham <manu@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>

diff --git a/drivers/media/dvb/ttpci/budget-ci.c b/drivers/media/dvb/ttpci/budget-ci.c
index 6b77b123f75ca5c8eef4b26fea7fd0417894a1a2..21f5e2c6b4c057b3ebf65c3af6c77c5e4b30e9a8 100644 (file)
--- a/drivers/media/dvb/ttpci/budget-ci.c
+++ b/drivers/media/dvb/ttpci/budget-ci.c
@@ -1768,6 +1768,29 @@ static void frontend_init(struct budget_ci *budget_ci)
                break;
 
        case 0x1019:            // TT S2-3200 PCI
+               /*
+                * NOTE! on some STB0899 versions, the internal PLL takes a longer time
+                * to settle, aka LOCK. On the older revisions of the chip, we don't see
+                * this, as a result on the newer chips the entire clock tree, will not
+                * be stable after a freshly POWER 'ed up situation.
+                * In this case, we should RESET the STB0899 (Active LOW) and wait for
+                * PLL stabilization.
+                *
+                * On the TT S2 3200 and clones, the STB0899 demodulator's RESETB is
+                * connected to the SAA7146 GPIO, GPIO2, Pin 142
+                */
+               /* Reset Demodulator */
+               saa7146_setgpio(budget->dev, 2, SAA7146_GPIO_OUTLO);
+               /* Wait for everything to die */
+               msleep(50);
+               /* Pull it up out of Reset state */
+               saa7146_setgpio(budget->dev, 2, SAA7146_GPIO_OUTHI);
+               /* Wait for PLL to stabilize */
+               msleep(250);
+               /*
+                * PLL state should be stable now. Ideally, we should check
+                * for PLL LOCK status. But well, never mind!
+                */
                budget_ci->budget.dvb_frontend = dvb_attach(stb0899_attach, &tt3200_config, &budget_ci->budget.i2c_adap);
                if (budget_ci->budget.dvb_frontend) {
                        if (dvb_attach(stb6100_attach, budget_ci->budget.dvb_frontend, &tt3200_stb6100_config, &budget_ci->budget.i2c_adap)) {